Please follow the safety instructions related to the PV strings and the utility grid. Otherwise, SUNGROW shall not be held liable
for any damage caused.
Contents may be periodically updated or revised due to product development. The information in this guide is subject to change
without notice. In no case shall this guide substitute for the user manual or related notes on the device.
Make sure to read over, fully understand and strictly follow the detailed instructions of the user manual and other related
regulations. Visit http://www.sungrowpower.com/, choose “PV Inverters” and search for the device model on the“Products” tab
page to view or obtain the user manual.
All operations can be performed only by qualified personnel, that must be trained in the installation and commissioning of the
electrical system, as well as the dealing with hazards, have knowledge of the manual and of the local regulations and
directives.
Before installation, check that the package contents are intact and complete against the packing list. Contact SUNGROW or
the distributor in case of any damaged or missing components.
The cable must be intact and well insulated. Operation personnel must wear proper personal protective equipment (PPE) all
the time.
Any violation could result in personal death or injury or device damage, and will void the warranty.
EN
PV strings will produce electrical power when exposed to sunlight and can cause a lethal voltage and an electric shock.
Only qualified personnel can perform the wiring of the PV panels.
All electrical connections must be in accordance with local and national standards.
Only with the permission of the utility grid, the inverter can be connected to the utility grid.
Do not open the enclosure at any time. Unauthorized opening will void guarantee and warranty claims and in most cases
terminate the operating license.
When the enclosure lid is removed, live components can be touched which can result in death or serious injury due to
electric shock.
Mfuibm!wpmubhf"
EBOHFS
All the warning labels and nameplate on the inverter body must be clearly visible and not be removed, covered or pasted.
XBSOJOH
Risk of burns due to hot components!
Do not touch any hot parts (such as heat sinks) during operation. Only the DC switch can safely be touched at any time.
DBVUJPO
Only qualified personnel can perform the country setting.
Unauthorized alteration of the country setting may cause a breach of the type-certificate marking.
OPUJDF
Tbgfuz
The warning label on the inverter body are as follows.
Disconnect the inverter from all the external
power sources before service!
Do not touch live parts until 5 minutes after
disconnection from the power sources.
There is a danger from a hot surface that
may exceed 60°C.
Danger to life due to high voltages! Only qualified
personnel can open and service the inverter. Check the user manual before service!
5 min
