
Care & Maintenance:
To minimize this condition, we recommend care when assembling & handling the product to prevent scratching
the paint. Should any scratching or damage occur, we recommend immediate touch-up with rust inhibiting paint.
Limited Manufacturer’s Warranty:
The item is warranted to be free from defects in material or workmanship for a period of Six (6) Months. We
don't reimburse for transportation or delivery costs, or compensate the individual or any outside party for
assembling or disassembling the product.
Exclusions:
Items used for commercial, contract, or other non-residential purposes, or items damaged due to acts of nature,
vandalism, misuse, or improper assembly are not covered. Corrosion or rusting of hardware is not covered. Proof
of purchase (dated register receipt) is required for warranty claims. Warranty is to the original purchaser and is
non-transferable. Any replacement of warranted items will be in the original style and color, or a similar style and
color if the original is unavailable or has been discontinued. As some states do not allow exclusions or limitations
on an implied warranty, the above exclusions and limitations may not apply. This warranty gives you specific
rights, and you may also have other rights, which vary from state to state. Made in China
No. Description Qty
A Base PC
B Support Post 1PC
C Basin 1PC
D Décor Part 1PC
E Branch 1PC
F M6x30 Stud 3PCS
G M6 Flat Washer 3PCS
H M6 Nut 3PCS
I M8x30 Stud 3PCS
J M8 Flat Washer 3PCS
K M8 Nut 3PCS
L M5x16 Screw 1PC
M M6X20 Stud 1PC
Parts List
Fig.1: Place the Basin (C) upside down on a soft and clean surface.
Fig.2. Attach Support Post (B) to Basin (C) by Studs M6x30 (F), flat washers (G) and nuts (H). Tighten the studs
and nuts. (Don’t over tighten) (Fig.1).
Fig.3. Attach Support Post (B) to the Base (A) by studs M 8x30 (I), flat washers (J) and nuts (K). Tighten the studs
and nuts. (Don’t over tighten)(Fig.2).
Fig.4. Stand the Birdbath on its base.
Fig.5. Attach the bird (D) to the branch (E) with the screw (L) (Fig.3).
Fig.6. Attach the branch to the threaded hole in the centre of the bowl (C) using the Stud M6x20 (M) (Fig.3).
Fig.7. Tighten all the nuts and screws.