Sunnydaze Decor WNC-321 User manual
Fountain Topper 1
Middle Tier 1
Bottom Bowl 1
Pedestal 1
Electric Submersible Pump 1
AC Adapter 1
TIERED PAGODA OUTDOOR WATER FOUNTAIN
WITH LED LIGHT
WNC-321
Read the assembly instructions carefully and follow the care instructions. Save these instructions for future reference.
Note: When rst used, there may be air in the pump. It may take several minutes for trapped air to escape, allowing water to ow.
Thank you for choosing Sunnydaze Decor. We stand behind our brand and the quality of the items we
sell. Replacement parts or products will be sent at our discretion within the 1-year warranty period. Proof
of purchase, with the date of purchase as well as photos of the merchandise defect, must be provided.
Photos are used to determine the cause of defects and for future quality control. Register your warranty at
www.serenityhealth.com/warranty/
If you have any questions, comments or concerns, feel free to contact us by phone at 888-881-4668, by email:
customerservice@serenityhealth.com, or via our contact us page at www.SerenityHealth.com/contact-us/
Purchase Date: / / Order/Customer Reference Number:
Inspect packaging to ensure all
parts are accounted for before
disposing of packaging.
WXF04789 Page 1 / 211/2019
ASSEMBLY
1. Place the bottom bowl onto the pedestal and twist to lock the pieces together.
2. Place the pump in the bottom bowl. Run the long pump power cord through the tube that is built into the bowl and
through the pedestal.
3. Firmly attach the AC adapter to pump power cord.
4. Locate the water tube and light cord that are in the fountain topper and run them through the middle tier.
5. Holding the topper and middle tier carefully:
a. Firmly attach the light cord to the short cable on the pump.
b. Attach the pump to the water tube; the connection will be airtight.
6. Making sure the pump is on the bottom of the bowl, place the middle tier onto the bottom bowl.
7. Fill the fountain with enough water to keep the pump fully submerged during operation.
8. Plug the power cord into a properly grounded GFCI outlet.
NOTE: The water tube is built into the fountain
topper, ensure the water tube remains intact. Do
not attempt to remove the water tube as it will
permanently damage the fountain.
2 people recommended for assembly.
1
2
3
4
6
2
5
b
a
7
8
IMPORTANT INFORMATION
WXF04789 Page 2 / 211/2019
GENERAL USE & CARE
• For outdoor use only. Some splashing is normal; adjust the flow rate on the pump if the water rate is too high.
• Check the water level frequently. Ensure the pump remains fully submerged; never allow the pump to run dry as it
will burn out the motor.
• Only use water in this fountain. Distilled water will help prevent mineral buildup but is not required, avoid heavily
chlorinated tap water as it may damage the fountain or pump.
• Periodically change the water to keep the water, fountain and pump clean. Remove scale and buildup regularly.
DO NOT use harmful additives such as bleach, chlorine, etc.
DO NOT use a pressure washer or abrasive materials to wash the fountain.
• Always shut off the power supply before cleaning and maintaining the fountain and the recirculating pump.
• Take care when handling the pump; only pick it up by the body of the pump, never the power cord.
• During winter and freezing weather, drain the fountain, disconnect the pump and store indoors; allowing ice to form
may crack the fountain.
TROUBLESHOOTING
• Ensure that the pump is fully submerged and add water to the basin if necessary.
• Check to make sure the power outlet is working; if in doubt about electrical connections, consult a certified electrician.
• Check the pump and tubing for obstructions.
• Make sure the pump is not suspended inside the middle tier or on top the tube that is built into the basin bowl.
• Check the flow control on the body of the pump as it may need to be adjusted to achieve the desired flow rate.
• If the light is not working, ensure the cables are fully connected and the seal is adequately tightened (do not over-
tighten the ring).
• If water is not flowing evenly, make sure the fountain is level. You may need to use shims (not included) to level
the fountain.
• If water is not flowing within several moments of the fountain being plugged in, unplug the power supply for a few
moments and plug it back in; the pump may have trapped air which can prevent water from circulating properly.
Table of contents
Other Sunnydaze Decor Lighting Equipment manuals
