Sunnydaze Decor DW-513 User manual

DW-513
Step 1) Take power cord from back of fountain, and plug into transformer.
Step 2) Close the opening in the back of the fountain with the included panel.
The power cord will fit in the notch of the panel.
Step 3) Pour water into the bottom of the fountain (recommend about 20 ounces),
making sure the pump is fully submerged.
Step 4) Plug the power cord into a power outlet.
Note: When plugged in for the first time, there may be air in the pump. It may take several minutes until all of the air
escapes and water begins to flow.

SAFETY GUIDELINES:
1. Read all instructions and safety guidelines thoroughly. Failure to follow guidelines and instructions could result
in serious injury and/or property damage.
2. Do not pump flammable liquids such as gasoline / fuel oil with the fountain pump.
3. Make sure the water tube is properly connected with the pump. Do not crimp the tube as this could cause a
blockage and water will not flow.
4. During operation, the pump will be submerged in water. Take care when handling the pump; do not pull it out of
the water by the power cord, and do not move it when running and still submerged in water.
5. Unplug the pump from electric power before servicing, cleaning, or moving.
CLEANING AND MAINTENANCE:
1. Check water level at the pump location regularly. The pump must be fully submerged with water to avoid
damage to the pump.
2. If, after time, the pump starts to lose power or stops working, check for the buildup of sediment or scale in the
Fountain Basin.
3. Remove the impediment or any dirt and scale.
4. Periodically change water and keep water clean. Distilled water is recommended to prevent mineral buildup.
This will improve the waterfall effect.