Sunnydaze Decor DW-520 User manual

DW-520
Step 1) Connect the pump to the hose on the inside of the fountain.
Step 2) Connect the LED lighting cord, located inside the fountain, to the transformer.
Step 3) Run power cords through the back of the fountain and slide the back panel into place.
Step 4) Fill your fountain with water (approximately 2.5 gallons), making sure the pump is fully submerged.
Step 5) Plug the power cords into power outlets.

IMPORTANT CARE NOTICE
•Fill fountain with sufficient water to ensure the pump is fully submersed.
•Clean and top-off the water on a regular basis.
•Always turn off power before cleaning and maintaining the pump.
•Never allow the fountain pump to run dry as this will cause damage and void the warranty.
•It’s not recommended to leave the fountain running constantly. We suggest turning the fountain off when not
present.
WINTER CARE
•During winter never allow ice to form in the bowls. Ice formation will crack the fountain.
•Drain the fountain and store indoors.
•The pump should be disconnected from the main supply, removed from the fountain and cleaned in the
following way:
oRemove the inlet cover from the front of the pump and gently grip the impeller to pull out the rotor
assembly, from the pump.
oClean the rotor and rotor housing with water, then dry with a towel.
oReassemble the parts and store the pump in a dry area.
TROUBLESHOOTING
If the water pump fails to operate, check the following:
1. If the pump cannot pump water check if the power is correctly connected and check if sufficient water is inside
the reservoir.
a. Check the pump and tubing for any form of obstructions.
b. Remove the cover with the pump flow adjuster on it and gently remove the inner cover to reveal the
pump impeller, and gently turn the rotor to check that it is not broken or jammed.
2. If the pump runs with slow water circulation check the following:
a. The flow control on the body of the pump.
b. Ensure the pump is completely submersed.
3. If any abnormal sound is heard during the pump operation, turn off the power supply and check the rotor
assembly as follows:
a. Remove the pump cover and rotor plate from the front.
b. Grip the impeller and gently take out the rotor assembly from the pump.
c. Rinse the motor assembly and the housing with clean water in order to remove any grit or debris.
d. If any breakage or surface damage is found on the rotor assembly, please contact your supplier if a
replacement is needed.
We hope you continue to enjoy your water feature for many years. Over time the paint finish will gradually mellow in
color, this is part of the natural weathering process.