Sunnydaze Decor TURTLE TRIO User manual

09/2019F12403 Page 1 / 2
TURTLE TRIO
OUTDOOR WATER FOUNTAIN
LZH-178
Read the assembly instructions carefully and follow the care instructions.
Keep these instructions for future reference.
Select a smooth, level surface to place the fountain. Assemble components of this

 
Turtle Trio Topper 1
Basin Bowl 1
Pedestal 1
Electric Submersible Pump 1
Thank you for choosing Sunnydaze Decor. We stand behind our brand and the quality of the items we
sell. Replacement parts or products will be sent at our discretion within the 1-year warranty period. Proof
of purchase, with the date of purchase as well as photos of the merchandise defect, must be provided.
Photos are used to determine the cause of defects and for future quality control. Register your warranty at
www.serenityhealth.com/warranty/
If you have any questions, comments or concerns, feel free to contact us by phone at 888-881-4668, by email:
[e-mail], or via our contact us page at www.SerenityHealth.com/contact-us/
Purchase Date: / / Order/Customer Reference Number:
Inspect packaging to ensure all
parts are accounted for before
disposing of packaging.
ASSEMBLY
STEP 1:
Align the tabs on the bottom of the basin bowl with the notches in the
top of the pedestal. Place the basin bowl onto the pedestal, twist to
lock them together.
STEP 2:
Run the pump power cable through the basin bowl and pedestal,
leaving enough slack to allow the pump to touch the bottom of the
basin bowl.
Pull the cord out through the groove on the back-side of the pedestal.

Note: When rst used, there may be air trapped in the pump. It may take several minutes for
trapped air to escape, allowing water to ow.
Page 2 / 209/2019F12403
IMPORTANT INFORMATION
USE & CARE
• For outdoor use only. Some splashing is normal; adjust the flow rate on the pump if the water rate is too high.
• Check the water level frequently to ensure the pump remains fully submerged; never allow the pump to run dry as it will burn out
the motor.
• Only use water in this fountain. Distilled water will help prevent mineral buildup but is not required, tap water may be used but avoid
heavily chlorinated water as it may damage the fountain or pump.
• Periodically change the water to keep the water, fountain and pump clean. Remove scale and buildup regularly.
DO NOT use harmful additives such as bleach, chlorine, etc.
DO NOT use abrasive materials to scrub the fountain
DO NOT use a pressure washer
• Always shut off the power supply before cleaning and maintaining the fountain and the recirculating pump.
• Take care when handling the pump; only pick it up by the body of the pump, never the power cord.
• During freezing weather, drain the fountain, disconnect the pump and store indoors; allowing ice to form may crack the fountain.
TROUBLESHOOTING
• Ensure that the pump is fully submerged and add water to the basin if necessary.
• Check to make sure the power outlet is working; if in doubt about electrical connections, consult a certified electrician.
• Check the pump and tubing for obstructions.
• Check the flow control on the body of the pump as it may need to be adjusted to achieve the desired flow rate.
• If water is not flowing within several moments of the fountain being plugged in, unplug the power supply for a few moments and plug
it back in; the pump may have trapped air which can prevent water from circulating properly.

STEP 3:
Firmly connect the pump to the tube that is built into the topper. A snug
t is to be expected.
Place the pump beside the tube that is built into the basin bowl. Make
sure that the pump is not 'oating' or resting on top of the tube.
STEP 4:
Align the notches in the bottom of the topper with the tabs on the top
of the basin bowl. Place the topper onto the bowl and twist to lock the
topper onto the bowl. Pay careful attention to the pump; make sure it
stays on the bottom of the basin bowl and does not detach from the
water tube.
Fill the fountain with enough water to keep the pump fully submerged
during operation.
Plug the power cord into an electrical outlet.