D- D+V+ V+ V- GND
DC IN PUT DMX I NPUT
DMX512 Wa ll P an el C on tr ol le r
DMX512 Master CDW Wall Control Panel
Wiring diagram
19.50 mm 71.00 mm
53.00 mm
12-24VDC
PSU
09.2201I.04043
Speed down, press and hold
down to decrease running speed
1. Set DMX Address
Set all DMX Decoder as DMX Address 001
3. Save color
1)Touch color wheel to choose the color
2)Press and hold down a target number over 3 seconds until LED light connected with the DMX decoder
flashes, the color is saved successfully, which will cover the default setting colors.
2. Default setting colors
100% Warm white 50% warm white +50% cool white
100% Natural white 50%Natural white +50% cool white
100% Cool white 50% Cool white +50% warm white
Press and hold down key to restore to default setting colors as follows:
12V/24V/36V
CV PSU
L
N
G
V+
V-
OUTP UT
INPU T
Conne ct w ith C DW L ED Stri p
V+ V+
WW- WW-
NW- NW-
CW- CW-
AC 100-240V
AC 100-240V
Function introduction
Important: Read All Instructions Prior to Installation
Speed up, press and hold down
to increase running speed
Kelvin running, click to
start running, click again
to pause
Brightness up/down, press
and hold down to increase/
decrease light intensity
Click to switch on/off
Color wheel, click or slide touch
to choose a color temperature
Save 6 colors, press and hold down to save the color/effect, click to recall the saved
Output Signal DMX512 signal
Power Supply 12-24VDC
Power consumption < 20 mA
Operating temperature 0-40°C
Relative humidity 8% to 80%
Dimensions 120x80x29.2mm
D- D+V+ V+ V- GN D
DC INPUT DMX INPUT
DMX512 Wall Panel Controller
Front side
Back side
DC Power input DMX512 signal output
83.00 mm
101.00 mm
• Touch sensitive
• Glass interface(white & black)
• Standard DMX512 Signal output
• Control CDW color(all white color)
• Waterproof grade: IP20
Product Data
D1 D1 D2 D 2
DMX512 De co de r
GND
whit e
0-5 0-9 0 -9
Conne ct w ith LED Str ipCDW
V+ V+
WW- WW-
NW- NW-
CW- CW-
D1 D1 D2 D 2
DMX512 De co de r
GND
whit e
0-5 0-9 0 -9
Operation
4. Recall the saved colors
Turn on the DMX master controller and click any of numbers of 1, 2, 3, 4, 5 and 6 to recall the saved colors.
• DO NOT install with power applied to device.
• DO NOT expose the device to moisture.
Safety & Warnings
