Sunwood 35MM BASSWOOD User manual

35MM BASSWOOD
SOLID TIMBER VENETIAN BLINDS
Installation Instructions
Tools Recommended for Installation:
Mounting Hardware:
( Note : Centre support supplied for blind width 100 cm or over)
Centre Support
Mounting Bracket Screw #1 Screw #2
Valance Return
Clip Hold Down
Bracket
Screw #3
Cord Cleat
Screw
Cord Cleat
1
Metal tape
measure Pencil Drill Phillips Head
Screwdriver
Step
Ladder
Drill Bit
(1/8” diameter)
When opening or closing blind, only raise or lower the blind 1.
when the slats are in the horizontal (open position). Larger
blinds must be raised or lowered in stages. Raising or
lowering in one singular motion places excessive stress
on the mechanism, strings and brackets.
It is not recommended that wooden blinds be fitted in2.
damp or wet environments as warpage may occur.
Dust blinds regularly.3.
If the blind becomes damp or wet, wipe down immediately.4.
The slats should be horizontal (open) and the blind
released and lowered completely. Allow to dry by
removing the blinds from the brackets and lay down
on a hard surface. Do not place in direct sunlight as
excessive heat may cause the slats to warp. If the
blinds are excessively wet, do not place the blinds
on to a surface that may absorb any stain.
This wooden blind does not require any oiling.5.
If you have any doubts about the care or maintenance
of your wooden blind, do not hesitate to contact your
nearest supplier for advice.
RECOMMENDED CARE FOR WOODEN BLINDS
WARNING
Reduce Risk of Strangulation to Infants and Toddlers.
Position Safety Cord-Stops before using Blinds.
Clamp or clothes pin
Cleat
1.
2.
WARNING! Children can be strangled in blind or
drapery cords. To keep cords out of reach of children, use
these methods:
124
3
Tie the cord to itself
Tie-down device
3.
4.
SUNWOOD
Do not force the cord when tilting the blinds, this may cause
The mechanism to break.
NOTE : Use of Hold Down Brackets is recommended to fully utilize the safety feature of the cord-stops.
1
2
3
4
To Position Safety Cord-Stops:
1
2
4
3
Cord-Stop
Lift cord
Cord-Stop
2.5 to 5 cm
Push both the cord-stop and
the loosened knot toward the
headrail until the cord-stop is
2.5 to 5 cm below the headrail.
Hold cord-stop in place and pull
firmly on lift cord to re-tighten
knot. Repeat steps 2, 3 & 4 for
each cord-stop.
If cord-stops ARE NOT 2.5 to
5 cm below headrail, loosen
(but do not untie) the knot
surrounding the cord-stop.
Measure the distance from
headrail to cord-stops.
If cord-stops are 2.5 to 5 cm
below the headrail, no further
adjustment is needed. Your
blind is ready to be used.
Install blind as directed by
manufacturer, making sure
headrail is securely fastened.
Lower blind to maximum
desired length and lock into
place.
Headrail
Headrail
Headrail
Valance Clip

WARNING
Young children can strangle in the loop of pull cords, chains, tapes that operate window coverings. They can
also wrap the cords around their necks. To avoid the risk of strangulation and entanglement, keep cords out
of the reach of young children. Move beds, cots and furniture away from window covering cords.