MV LINE CLARA 015 Instruction Manual

1
5 8
10
2
6
12
15
3
13
4
7
119
14
Fix the clips to the wall. We
recommend it for big dimen-
sions.
Insert the compensating profi-
le in the upper end-cap.
Fix the compensating profile
throught the prepared hole.
Place the latcht-guide, lift
up the lower rail to fasten
them, then put down the
lower latch guide.
Insert the upper end-cap to
the box.
Insert the guide in the com-
pensating profile.
Join the box the the brackets and
press until you hear a click.
Insert the lower latch-guide in
the closure profile.
Insert the upper conveyer
in the guide.
Verify the proper operation
of the insect screen.
Fix the upper and lower end-
caps.
Place the closure profile and
fix it.
Fix the latch-guide.Insert the lower rail in the end-
cap.
Adjust the screws with a
wrench to correct the pos-
sible upper irregularities of
the walls.
CLARA 015
INSTALLING INSTRUCTIONS
The installation of the insect screen should be made by qualified personnel following the instructions listed below.
Use screws or anchors suitable for the type of wall on which the insect screen will be installed. Make sure that the jambs are parallel and at right-angle; in case of out of
square walls make the necessary adjustments to ensure parallelism to the profiles of the insect screen.

This document is an integral part of the product and is intended for
the benefit of all persons using the screen (users + installation and
maintenance operators).
All the instructions listed in this document comply with the EU Ma-
chinery Directive and provides for the correct use, installation and
maintenance of the screen, with the aim of avoiding damage to per-
sons and to the product.
MV LINE would like to congratulate you on your purchase of
this insect screen.
This guide will help you appreciate the advantages of this screen
and assist you during the use, installation and maintenance phases.
The company reserves the right to implement partial or complete
modifications without prior notice and declines any responsibility
in relation to any possible inaccurate or incomplete information.
This guide is the property of MV LINE.
Reproduction (even partial) of this document is expressly
prohibited without prior authorisation from MV LINE.
INTENDED USE
The insect screen is intended, as its name would suggest, to act
as a protective screen against intrusive insects in the room or area
where it has been located. Any other use shall be considered im-
proper. The manufacturer will not be held responsible for damage
arising from improper, erroneous and irrational use.
PACKAGING, MOVEMENT AND TRANSPORT
• The screens are packaged in transparent bags, cardboard and
polyethylene wrapping which protect the unit during transport.
• The screen can be moved by hand and does not require any spe-
cial equipment to facilitate movement.
• Please take every precaution to avoid any possible damage to the
screen.
• After removing the packaging, check that the screen is in per-
fect condition and that there are no visibly damaged parts.
If in doubt, do not use the screen and contact the supplier.
ATTENTION!!!
Packaging materials must not be left within the reach of children.
USE
Avoid use (opening and closing of the screen) by children.
MAINTENANCE
Regularly clean the magnetic parts using a damp cloth.
• In the case of wear and tear, lubricate the bearings using a silicone
spray.
• All extraordinary maintenance operations must be carried out by
suitably qualified personnel.
• Spare-parts are available from retailers or directly from MV LINE.
DISASSEMBLY AND DECOMMISSIONING
Before disassembling the screen, please consult the instructions
manual. The screen does not contain dangerous materials. There
are no specific guidelines for decommissioning or disposal.
GUARANTEE
Do not disassemble apparently malfunctioning parts or accessories
on your own initiative, please contact the retailer who shall organise
technical support and spare-parts, failure to do so will aect the
conditions of the guarantee. The guarantee includes the complete
or partial replacement of the unit or parts in the case of functional
issues arising from manufacturing defects and is exempt from dam-
age and deterioration caused by the customer.
In order to use the guarantee you must copy the INSECT
SCREEN CODE as displayed on the label attached to the
screen housing into the white space below (see fac-simile
fig. 1) and attach the relevant proof of purchase (receipt
or invoice).
This screen is guaranteed by MV LINE for a period of 24 months.
Code:
PRODUCT INFORMATION
USE • MAINTENANCE • GUARANTEE
Find and copy the code
displayed on the label
attached to the screen
housing as shown here.
DECLARATION OF CONFORMITY
The undersigned MV LINE s.p.a.
Via Umbria - Lotto 69 70021 Acquaviva delle Fonti (BA), Italy
Hereby declares that the product:
complies to the following EU directives (including all applicable
modifications):
Machinery Directive 89/392/CEE and Norm UNI EN 13561 Ap-
pendix ZA.1
Year of CE marking: 2014.
Acquaviva delle Fonti, 01.01.2014
Signature
Paolo Montanaro
(CEO)
CLARA 015
EN 13561
06
MV LINE s.p.a.
Via Umbria - Lotto 69 70021
Acquaviva delle Fonti (BA), Italy
Product: INSECT SCREEN
Class: NPD