Benthin P1614 User manual

Installation Installation – Operation – CareInstallation
Care
Thanks to a special manufacturing process, our fabric qualities are
furnished with an antistatic finish and are therefore resistant to
dust and dirt.
Occasional brushing with a soft brush or a feather duster is usually
sufficient.
When cleaning glass and the window frame, make sure that no
water or caustic cleaning agents come into contact with the
pleated blind fabric.
No guarantee can be offered for damage to fabrics that is
attributable to condensate, cleaning agents or soiling by insects.
For further care information refer to the cleaning instructions.
© 2016 Benthin®.Misprints, errors and changes excepted .Version 30-06-2016 .97000249
Model P1614
Please read this intructions carefully
before fitting the blind
Blinds must be fitted by skilled personnel.
Wrong installation may result in accidents.
Alterations of the blind must be approved by the blind manufacturer.
Dear Customer,
this dimensionally accurate pleated blind was produced especially
according to your requirements. High qualilty materials and a design that is
perfect in function and elegance guarantee a long service lifetime and thus
ensure great pleasure in the purchased product.
Your pleated blind Manufacturer
6. Operate the pleats and check the function
The handle allows the pleats to move smoothly to any desired
position. Après vérification du bon fonctionnement du store,
les bouts de cordons excédentaires peuvent être coupés.
Operating
handle
Attention: Adjustment of the cord tension must be uniform and
may only be made by a professional!
A
B
A
B
Variant A
Pleated blind
IN
of the glazing bead
Variant B
Pleated blind
IN FRONT
of the glazing bead
Clamping
carrier
Tension cord
bracket
1
2
3
4
5. Assemble pleat
Slide the tension cord bracket onto the clamping carrier.
A
B

Installation InstallationContent
Installation
1. Prepare clamping carrier
Clip the front piece and rear piece of the clamping carrier together
to the first position.
1 x
4 x
Clamping carrier
rear piece
First position
Outer edge of
pleat
Clamping
carrier
centre
1 x
4 x
3. Assemble clamping carrier
Fit the clamping carrier to the marked position on the window
frame and press together until it clicks.
Press
clamping carrier
together
4. Remove rubber band
and unwind the cord incl. tension cord bracket.
TOP!
Tension cord bracket
Cord
Rubber band
2a. Determine the position of the clamping carrier
Variant A: Pleated blind IN the glazing bead
Mark the setting width on the window frame.
Outer edge of pleat = Centre of clamping carrier.
Note: The setting width can be easily determined by laying the
pleat on the window, and marking the outer edge of the pleat.
2. Mount handles.
Slide both handles sideways onto the adapter.
Clamping carrier front piece
with distance plate
Clamping carrier
rear piece
First position
4 x
Clamping carrier
centre
Outer edge of
pleat
2b. Determine the position of the clamping carrier
Variant B: Pleated blind IN from of the glazing bead
Mark the setting width on the window frame.
Outer edge of pleat = Centre of clamping carrier.
Note: The setting width can be easily determined by laying the
pleat on the window, and marking the outer edge of the pleat.
A
B
Variant A
Pleated blind
IN
the glazing bead
Variant B
Pleated blind
IN FRONT
of the glazing bead
A
B
or
A
B
A
B
Clamping
carrier
centre
2 x