superbrightleds DMX3-4CH-4A User manual

4-Channel DMX512 Decoder
Important: Read all instructions prior to installation. DMX3-4CH-4A
4400 Earth City Expy, St. Louis, MO 63045 866-590-3533 superbrightleds.com
Rev Date: V1 04/18/2022
User Manual
Safety and Notes
• Product should be installed in accordance with applicable
national, state, and local building and electrical codes.
• To reduce the risk of electric shock, ensure that the main power
source and circuit breakers are switched o󰀨 before performing
any installation or wiring procedures.
• Ensure all mounts are securely attached and will support the
weight of the decoder. Failure to properly secure it may result
in damage or injury, for which the manufacturer does not
assume responsibility.
• A DMX console is required for proper use of this decoder.
Specications
Technical Specications
Operating Temperature -4°–140° F (-20°–60° C)
Supply Voltage 12–24 VDC
Max. Output Current up to 4 A per channel, up to 15 A total
PWM Output 4 Channels
DMX512 standard DMX512/1990
Connections and Controls
RJ45 input and output power input and load outputsetting adjustment buttons

4-Channel DMX512 Decoder
Important: Read all instructions prior to installation. DMX3-4CH-4A
4400 Earth City Expy, St. Louis, MO 63045 866-590-3533 superbrightleds.com
Rev Date: V1 04/18/2022
User Manual
Operation
Button Function
Each decoder will occupy 4 address codes. The rst character on the display will be A, H, or S to display the function setting.
The remaining three characters will be the DMX address (001–512) or the mode selection.
When in mode ‘A’, the decoder is being controlled by the DMX console. The digital display will show the rst DMX address
with the next three consecutive numbers being the remaining channels the decoder will use. So if the display shows ‘A001’,
this means that the rst channel is 001 and the other three channels are 002, 003, and 004 respectively. When connecting
to an additional decoder, the default value of the next decoder’s rst channel would be 005 and the others three channels
of it would be 006, 007, and 008 in this example.
When in mode ‘H’, the decoder is using the built-in test mode programs. The remaining three character spots will display the
below codes to indicate which program is currently selected.
Display Mode Display Mode
-00 Turn OFF output -05 Static Purple
-01 Static Red -06 Static Cyan
-02 Static Green -07 Static White
-03 Static Blue -08 Seven Color Jump (Speed Adjustable)
-04 Static Yellow -09 Seven Color Fade (Speed Adjustable
When in mode “S”, press the SET button to enter the speed adjustment setting for H-08 and H-09, then press the +/- buttons
to adjust pattern speed.
SET button: Mode selection switch. Hold for about 2 seconds to cycle to the next mode (A/H/S).
+and -buttons: These increase or decrease the DMX address value or select mode setting.

4-Channel DMX512 Decoder
Important: Read all instructions prior to installation. DMX3-4CH-4A
4400 Earth City Expy, St. Louis, MO 63045 866-590-3533 superbrightleds.com
Rev Date: V1 04/18/2022
User Manual
Wiring Diagram (common application)
DMX Console
LED Strip
LED Strip
Power
Supply
Power
Supply 12–24 VDC
12–24 VDC