SUR-RON Light Bee User manual

For shipping reasons, the anufacturer sets the rear shocker to
a default level, please adjust the rear absorber accord to your
weight and riding habit before use.
If the reversed front shocker (e.g. FASTACE) is chosen, please
use Wrench (# 19) to tighten the axle, use # 5 inner hexwrench
to tighten the 4MG bolts in the bottom of the absorber.
The tighten torque is 8~10N.
Note :
Rear Shocker Adjustment
1. Make the 4 black nylon tighten strips(200mm) go through
the 4 holes on the number plate as the picture shown.
2. Tighten the number plate on the front fork as the picture shown.
1. Using the Hex wrench( #8)
to get off the front tire axle.
2. Put the front tire into the
installation position of the front
fork (Please sure the
front tire moun ting will
be well matched with the
disc brake's clipper).
3. Insert the front tire axle,
and make sure the axle will
go through the front tire and
fork as the picture shown.
4. Use the Hexwrench
(#8) to tighten up the
front tire axle.
Number Plate
Installation
Front Tire
Installation
www.elecycles.com [email protected]