Sylvania SYL-06ES User manual

SYL-06ES

All the illustrations in this manual are for explanation purposes only. Your air
conditioner may appear slightly different from the illustration.
NOTE:

Keep away from firearms

Operation of Curr ent Detection Device
Applicable only to units with current detection device
On some products this is also indicated by
a light on the plug head.

Unit may vibrate and make noise
because of poor wall, window
construction, or incorrect installation.

The following instructions represent the Unit Controls, the same instructions apply to the
NOTE:
Remote Control.

The indicator light will be illuminated once the
mode is selected.
Not available in cooling
only models
In Fan only mode, the temperature is not adjustable.
program can be cancelled at any time during operation
by pressing the Sleep button again.
The Sleep mode

To initiate the AUTO START program, first press the Timer
button which illuminates the TIMER ON indicator.
To initiate the AUTO STOP program, while the TIMER ON
is displayed, press the TIMER button again so that the
TIMER OFF indicator light illuminates.

Top rail and Sliding Panels at each side are offset to provide the proper pitch to the rear of
the Unit.
Place unit on floor or stable surface.
When installed, the flange for securing the panel in place to
the window sill, will be facing into the room.
Slide the free end (I section)

Styrofoam in unit should
not be removed.
Keeping a firm grip on air conditioner, raise sash
and carefully "rock" air conditioner backward to
drain any condensated water in base of unit.
Becareful not to spill any remaining water while
lifting unit from window.

The filter may be vacuumed instead of
washing.