Page 1 of 2
Installation Instructions: p/n 16032926-01 rev A
COMPUTER ACCESSORIES
Modesty Panel
ErgoStat® Pro
PRODUCT NUMBERS
PMPxx
HARDWARE PACK
PMP2HP or PMP3HP (p/n 17091403-02 or -03)
REQUIRED TOOLS
#2 Phillips Screwdriver
Tape Measure
5⁄32" Hex Wrench
1. Preassemble a nut plate to each rail bracket using
(2) #8-32x3⁄8" Phillips at head screws. Leave ap-
proximately a 1⁄8" gap between the bottom of the
bracket and top of nut plate. Modesty Panels that are
48" wide or less will require two bracket sets. Three
bracket sets are required for panels wider than 48".
2. Slide the bracket sets into the top of the rail. For
panels larger than 48", center one bracket set over
the width of the rail and tighten with a #2 Phillips
screwdriver. Position the remaining bracket sets
1.56" from each end of the rail and tighten securely.
3. Slide the modesty panel into the bottom slot of the
rail.
4. Slide the cable trays in the rail slot, centering tray
between pass-thru notches in modesty panel.
rail bracket
(17032101-01)
rail top
1.56"
Gap = "
Nut Plate
(13072406-01)
#8-32x" screw
(12012703-03)
