Symbol LS 9208 Manual

Setup Instructions for
Gilbarco Passport
LS 9208

LS 9208 Setup Instructions
2
Introduction
This document provides instructions on programming the Symbol LS 9208 scanner for use with a Gilbarco Passport system.
Required Hardware
•Cable
• 25-32465-20 (RS232 Cable, DB9 Female, TxD on 2, 6 ft. Straight), or
• 25-32465-21 (RS232 Cable, DB9 Female, TxD on 2, 8 1/2 ft. Coiled), or
• 25-60262-20 (RS232 Cable, True TTL, DB9 Female, TxD on 2, 6 ft. Straight), or
• 25-60262-21 (RS232 Cable, True TTL, DB9 Female, TxD on 2, 8 1/2 ft. Coiled).
• Power Supply
• 50-14000-008 (110VAC for N. America), or
• 50-14000-009 (220VAC for Europe and Asia), or
• 50-14000-010 (100VAC for Japan).
Scanner Setup
The following parameters need to be set:
•SetDefaults
• Fujitsu RS-232
• Baud Rate 9600*
• Parity Even
• 1 Stop Bit*
•7-Bit
• Convert UPC-E to UPC-A
• Transmit UPC-A Check Digit*
• Transmit UPC-E Check Digit*
• None (No code ID character)
* Already set by default
Scan the following bar codes to configure the LS 9208 Scanner.
1
Set Defaults

3
2
Fujitsu RS-232
3
Even
4
7-Bit
5
Convert UPC-E To UPC-A
(Enable)
6
None

LS 9208 Setup Instructions
4
73-60833-SI02
Revision A - September 2004
Symbol Technologies, Inc.
One Symbol Plaza
Holtsville, N.Y. 11742-1300
http://www.symbol.com