Symmons 0368-3HDH Manual

Model Number Specification
Dimensions
Limited Lifetime - to the original end purchaser in
consumer installations.
5 Years - for commercial installations.
Refer to www.symmons.com/warranty for complete
warranty information.
Warranty
Hair Dryer Holder
Operation & Maintenance Manual
0368-3HDH
Note: Dimensions subject to change without notice.
For California Residents
WARNING: This product contains chemicals known to
the State of California to cause cancer, birth defects, or
other reproductive harm.
Compliance
0368-3HDH Hair Dryer Holder Hair dryer holder made from metal construction, plated in
standard polished chrome nish.
Measurements
A 1-1/4", 32 mm
B 3/8", 10 mm
C 5", 127 mm
D 3-1/8", 79 mm
E 1-1/4", 32 mm
F Ø 3", 76 mm
G(2x) Hole Size
Ø 5/16", 8 mm
H Ø 5/16", 8 mm
AA
BB
CC
DD EE
FF
GG
HH

Symmons Industries, Inc. ■31 Brooks Drive ■Braintree, MA 02184 ■Phone: [phone] ■ Fax: [phone]
Copyright © 2017 Symmons Industries, Inc. ■symmons.com ■[email protected] ■ZV-3193 REV 0 ■040617
Parts Breakdown
A
B
B
C
D
D
EE
Installation
Troubleshooting Chart
Problem Cause Solution
Finish is spotting Elements in water supply may cause
water staining on nish.
Clean nished trim area with a soft
cloth using mild soap and water or a
non-abrasive cleaner and then quickly
rinse with water.
Replacement Parts
Item Description Part Number
B
DMounting Hardware Kit RA-019
Tools Required
Allen Wrench (3/32")
Drill
Phillips Head
Screwdriver
C
2
1) Place mounting bracket (C) into
desired position and mark drill
hole locations. Remove mounting
bracket (C) and install two self
drilling anchors (D) into wall.
2) Reposition mounting bracket (C) on
self drilling anchors (D) and secure
to wall with two screws (B).
C
2
D
B
1
D
B
3) Attach hair dryer holder (A) to
mounting bracket (C). Secure with
two set screws (E).
A
1
C
EE
2