System air Topvex SR35 User manual

Installation Guide ODK Roof 1 (3)
Roof installation
Danger
Disconnect the mains power supply to the unit before performing any work.
Caution
Risk of injury through pinching. Use protective clothing.
Enclosed in the kit:
Corner brackets
4 pcs for all Topvex
Side bracket
2 pcs for Topvex SR20-35, SC20–60
4 pcs for Topvex SR60-100, SC70
Sheet metal screws with rubber seal
24 pcs for Topvex SR20-35, SC20-60
32 psc for Topvex SR60-100, SC70
Roof parts
2 pcs
3 pcs for Topvex SC70
Systemair Sverige AB · Industrivägen 3, SE-739 30 Skinnskatteberg, Sweden
Phone [phone] Fax [phone] 247576-en_GB- vA002

Installation Guide ODK Roof 2 (3)
Fig. 1 Place the corner and side brackets on top of the air handling unit. Position the roof to make sure the side brackets are in correct position.
Use the side bracket as a template and mark the position. Fasten the brackets with the enclosed screws.
Systemair Sverige AB · Industrivägen 3, SE-739 30 Skinnskatteberg, Sweden
Phone [phone] Fax [phone] 247576-en_GB- vA002

Installation Guide ODK Roof 3 (3)
1
2
Fig. 2 Place the left (1) roof part on top of the air handling unit. Fasten
the roof part to the brackets with the screws. Fasten the right roof part
(2), observing the bending on the inner edge of the right roof part.
1
2
3
Fig. 3 For Topvex SC70 the roof are in three parts. Position the roof to
make sure the side brackets are in correct position. Use the side
brackets as a template and mark the position. Fasten the brackets with
the enclosed screws. Fasten the roof parts (1), (2), (3) to the brackets,
observing the bending on the inner edges of the middle roof part (3).
Systemair Sverige AB · Industrivägen 3, SE-739 30 Skinnskatteberg, Sweden
Phone [phone] Fax [phone] 247576-en_GB- vA002