TA Instruments TMA Q400 User manual
Issued June 2017 Page 1 of 6
TA Instruments
Packing the TMA Q400
This procedure covers the steps for properly packing up the TMA Q400 for shipment.
Packing Procedure
1Remove the probe and stage from the instrument
2Remove the outer cover around the shuttle assembly.
3Remove the weight tray. Tape the nylon screw in place and lay the weight tray in the top of the furnace.
See Figures 1 and 2.
Figure 1
Page 2 of 6
Figure 2
4Remove the 8 shoulder screws from the front support bracket.
Figure 3
5Carefully slide the front support bracket between the upper and lower suspensions, behind the weight
tray mounting bracket.
Figure 4
Page 3 of 6
6Carefully slide the rear supports between the upper and lower suspensions.
Figure 5
7Install the shoulder bolts through the front support bracket and thread them into the rear support
brackets.
Figure 6
8Remove one of the bolts from the outer clamp and install the outer clamp. The clamp should go above
and below the upper and lower suspensions.
Figure 7
Page 4 of 6
9Install the bolt in the other end of the outer clamp and tighten. The suspension is now immobilized.
Figure 8
10 Install the rear shipping foam support under the lower weights.
Figure 9
11 Lower the furnace. Tape the weight tray into the top of the furnace.
Page 5 of 6
12 Place the cardboard sleeve over the furnace lift shaft See Figures 10 and 11.
Figure 10
Figure 11
Page 6 of 6
13 Tighten the lockdown cap into the top of the furnace lift shaft. This immobilizes the furnace.
Figure 12
14 On the Q400 display panel, press the Control button.
15 Press the Shutdown button, then press Apply. Wait for the display screen to show that the instrument
is shutdown and it is safe to turn off the instrument.
16 Turn off the power switch located on the back of the instrument near the power cord.
17 Bolt the Q400 down on the shipping pallet. Place the cardboard box over the pallet.
18 Strap the cardboard box down over the pallet and instrument.
19 Seal the box and place the green return label on the top of the box.
Table of contents
Other TA Instruments Measuring Instrument manuals
TA Instruments
TA Instruments TGA 2950 User manual
TA Instruments
TA Instruments ARES-G2 User manual
TA Instruments
TA Instruments TMA 2940 User manual
TA Instruments
TA Instruments DISCOVERY XENON FLASH User manual
TA Instruments
TA Instruments AR 2000 User manual
TA Instruments
TA Instruments DHR Series User manual
TA Instruments
TA Instruments TMA 2940 User manual
TA Instruments
TA Instruments Q1000 User manual
TA Instruments
TA Instruments TMA 2940 CE User manual
TA Instruments
TA Instruments Nano ITC Series User manual
