Tape King TX100 Administrator Guide

A
B
C
DE
F
G
H
A
B
C
D
E
F
G
H
Clear Plastic Swiper
Blue Blade Cover
Black Roller Guide
Metal Clasp
Ergonomic Handle
Roll of Tape
Blue Round Knob
Tape Roll Holder
TX100 / TX300
Parts Locator & Identifer
> Watch our installation video on YouTube
> Search for “Tape King TX100” and subscribe
Enjoy our hassle-free, no questions asked, one-year warranty! Need help? Please contact us [email protected]
Page 1 of 2

TX100 / TX300
How to: Step By Step
> Watch our installation video on YouTube
> Search for “Tape King TX100” and subscribe
How to: Step By Step
1 2 3
4 5 6
Congratulations on purchasing the
Tape King packing tape gun.
Insert the roll of tape into tape roll
holder (H). Make sure the sticky
adhesive side is facing down before
peeling off the tab.
Adjust the blue knob (G) clockwise to
tighten brake tension or counter
clockwise to loosen. We recommend
turning it clockwise a few times but do
NOT overtighten. Adjust to your liking.
This controls the roller speed while
dispensing tape.
Remove the blue plastic blade cover
(B). Take caution while removing to
avoid cutting yourself on the sharp
blade. Use your fingers or a small
tool to pry it off if stuck.
Begin taping your box with 2-3” of
tape to seal the seam and pull the
tape gun, rolling it towards your
body.
Pull the tape out using the
starting guide tab arrows. Align
the tape between black roller (C)
and metal clasp (D). Make sure
the sticky side is facing down.
Pull the tape out and use blade
to make the first cut before
taping boxes.
TIP: Use the clear swiper (A) and
tilt forward while cutting the tape
off. Don’t use too much force or it
may break. Use swiper (A) after
taping, press down on the tape in
a swiping motion to create a
better seal.
Page 2 of 2
> Watch our installation video on YouTube
> Search for “Tape King TX100” and subscribe
Enjoy our hassle-free, no questions asked one-year warranty! Need help? Please contact us [email protected]
sticky side