Targus Stow-N-G User manual

USER GUIDE
Wireless
Stow-N-Go™
Rechargeable
Notebook mouse

Table of Contents
System Requirements . . . . . . . . . . . . . 3
Installing the Batteries . . . . . . . . . . . . . 4
Connecting the Mouse Receiver . . . . . 6
Switching Channels . . . . . . . . . . . . . . . 6
Storing the Receiver . . . . . . . . . . . . . . 8
Power Save Mode . . . . . . . . . . . . . . . . 9
Troubleshooting . . . . . . . . . . . . . . . . 11
Technical Support. . . . . . . . . . . . . . . . 12
2

TARGUS WIRELESS
STOW-N-GO™
RECHARGEABLE
NOTEBOOK MOUSE
Introduction
Congratulations on your purchase of the Targus Stow-N-
Go™ Mouse. This ergonomically designed mouse uses
leading-edge radio frequency (RF) technology that
enables you to use the mouse anywhere up to 15 feet
(4.57 m) of its receiver, in a 360 degree range of
operation.
This mouse also features eight communication channels
with automatic channel-hopping capability. This feature
reduces the likelihood of interference from other RF
devices. Using multi-channels make it ideal for use in
areas where more than one RF device is used, such as a
conference room or office area.
NOTE: THIS MOUSE IS A HIGH RESOLUTION DEVICE. FOR MAXIMUM
ACCURACY AND EFFICIENCY,IT IS RECOMMENDED THAT YOU SET YOUR
DISPLAY RESOLUTION TO 1024 X768 PIXELS OR HIGHER WHILE YOU ARE
USING THE MOUSE.
Contents
• Wireless Stow-N-Go™ Rechargeable Notebook Mouse
• Storage pouch
3

Targus Wireless Stow-N-Go™ Rechargeable Notebook Mouse
• USB receiver (stored in compartment of mouse)
• USB charge cable
• Two AAA rechargeable batteries (You will need to
charge the mouse at least 8 hours before using it.)
System Requirements
Hardware
• PC with an Intel®Pentium®processor or equivalent
• USB interface
Operating System
• Windows®2000/ME/XP
NOTE: THE THIRD BUTTON AND THE SCROLLING WHEEL ONLY WORK WITH THE
OPERATING SYSTEMS LISTED ABOVE. IF YOU USE THE STOW-N-GOMOUSE
WITH A DIFFERENT OPERATING SYSTEM,IT WILL LOSE ITS ENHANCED FEATURES
AND FUNCTION AS A STANDARD,TWO-BUTTON MOUSE.
Installing the Batteries
1 Remove the battery cover from the back of the
mouse.
Rechargeable
AAA
Non-Rechargeable
• Windows Vista™
4

Targus Wireless Stow-N-Go™ Rechargeable Notebook Mouse
2 Insert the supplied batteries, making sure that the
positive (+) and negative (-) ends of each battery
match the polarity indicators inside the battery
housing.
WARNING: AVOID MIXING NEW AND USED BATTERIES IN A DEVICE.
3 Replace the battery cover into position until it “clicks”
firmly into place.
Charging the Mouse
This mouse comes with rechargeable batteries. For best
results, you should charge the mouse, via the supplied
USB charge cable, at least 8 hours before using it. To do
this:
1 Connect the cable’s USB connector into an available
USB port on your computer.
2 Connect the other end to the mouse.
NOTE: TO CONTINUOUSLY CHARGE THE MOUSE VIA THE USB CHARGE CABLE,
YOUR COMPUTER MUST BE ON AND AWAKE. FOR BEST RESULTS,TURN OFF
YOUR COMPUTER’S POWER MANAGEMENT FEATURE WHILE CHARGING THE
MOUSE.
YOU MAY CONTINUE TO USE THE MOUSE WHILE IT IS RECHARGING.
5

Operating Notes for Wireless Mice with
Recharging Feature via USB Cable
1. Charge the mouse for at least 8 hours before using it. And please
make sure only rechargeable batteries (the ones that come with your
product) are used.
2. Your computer needs to stay powered on for the mouse to charge.
Follow these steps to prevent your computer from going in to
Standby or Hibernate:
a) Click “Start”
b) Click “Control Panel”
c) Click “Performance and Maintenance” (Skip in Classic View)
d) Click “Power Options”
e) Make sure “System Standby:” and “System Hibernates:” under “Plugged
in” are set to “Never”
3. If you use your notebook computer’s LCD monitor, please do not
close the lid. (Please ignore this step if you use an external monitor
with your notebook lid closed.)
4. If your mouse does not respond after a period of inactivity, please
wake it up by pressing one of the buttons on the mouse or moving
the mouse around.
Targus wireless keypad and mouse combo
6

Targus Wireless Stow-N-Go™ Rechargeable Notebook Mouse
Low Battery Indicator Light
When the battery charge is running low, the light emitter
diode (LED) on the scroller wheel flashes.
CAUTION: IF THE INDICATOR LIGHT IS FLASHING,IT IS HIGHLY
RECOMMENDED THAT YOU CHARGE THE MOUSE AS SOON AS POSSIBLE TO
PROPERLY MAINTAIN THE BATTERIES.
Connecting the Mouse Receiver
To connect the mouse receiver:
1 Press the eject button on the bottom of the mouse.
2 Take the receiver out of the compartment.
3 Plug the USB receiver into an available USB port on
your computer and follow any on-screen instructions
to complete the default driver installation.
7

Targus Wireless Stow-N-Go™ Rechargeable Notebook Mouse
4 The communication link between the mouse and
receiver is preset at the factory so the mouse should
now be ready to use.
Switching Channels
In some instances, radio frequency interference may
require you to switch to an alternate channel. To do this:
• Press and release the reset button, located on the
bottom of the mouse.
Within 5-10 seconds the mouse will automatically
switch to another channel and again respond to
movement.
8

Targus Wireless Stow-N-Go™ Rechargeable Notebook Mouse
Storing the Receiver
Place the receiver at a 90° angle and press the receiver
into the compartment.
The receiver will click into place when properly inserted.
NOTE: WHEN THE RECEIVER IS STORED IN THE MOUSE’S STORAGE
COMPARTMENT,THE POWER IS AUTOMATICALLY SHUT OFF.
Power Save Mode
To conserve the battery, the mouse reduces its power
consumption gradually when not in use by entering into
sleep mode. Move the mouse to resume normal
operation.
Operating Hints
For optimal performance and RF reception:
• Turn off your computer’s power management feature
before charging the mouse so that your computer
doesn’t enter sleep mode, which temporarily halts the
charging process.
• Avoid using the mouse on a metal surface. Metals,
such as iron, aluminum or copper, shield the radio
9

Targus Wireless Stow-N-Go™ Rechargeable Notebook Mouse
frequency transmission and may slow down the
mouse’s response time or cause the mouse to fail
temporarily.
• The mouse will enter a suspend mode at the same time
your computer does. Move the mouse to reactivate.
• If your computer has a metal case that contains
aluminum or magnesium, use the mouse to the side.
The display panel may interfere with the radio
frequency signal if you use the mouse directly in front
of the computer.
• Never use the mouse on a glass or mirrored surface as
these surfaces will cause the mouse to fail temporarily.
• To maximize battery life, use the mouse on a white, or
light colored surface. Dark surfaces cause the mouse’s
light emitter diode (LED) light to glow brighter, which
causes the battery to discharge more rapidly.
Comfortable Usage
Research suggests that physical discomfort and injury to
nerves, tendons, and muscles may be related to
repetitive motion, an improperly set up work area,
incorrect body posture, and poor work habits.
To reduce the risk of injury, follow these precautions:
• Stand, stretch, and move around several times every
hour.
• Switch hands while performing tasks. Use shortcut
keys to avoid repetitive or awkward mouse
movements.
10