Team Losi XXX-NT Sport Ready-to-Run User manual

Refer to Figure 91 in the Owners Manual to install
the radio antenna on the truck. Install the radio
system batteries, 8 in the bottom of the transmitter and
4 into the back of the model as shown. Use only quality
alkaline or rechargeable Ni-Cad AA-size cells.
Radio Batteries
Ignitor Battery
Remove the cover from the glow plug ignitor.
Install a “C” size alkaline battery with the “+” end
of the battery as shown in the figure above.
Throttle Brake
Throttle Brake
Steering
Steering
Operations Check
Always turn the transmitter “on” first and check the display screen
for adequate voltage. Turn on the model and check both the
throttle and steering for proper operation and battery power.
“C” Size
+ Pos
- Neg
Slide back the battery access panel opposite the hand strap and
remove the cover. Remove hex starter shaft from the back side
of the cover (fig 2a.) and press the o-ringed end into the drive
cup. Slide a 7.2 volt 6 cell “stick pack” into the Spin-Start and
plug it in. Note that the plug is made such that it can be plugged
in one way. Carefully tuck the plug wires under the battery ac-
cess panel and slide shut.
Spin Start Battery Install
Fueling
Lift the lid of the fuel tank, place the tube of the
fuel bottle into the opening and carefully fill the
tank. Do not allow fuel to overflow as spilled fuel
can cause radio damage.
Getting Started
Getting Started
Before you start running your XXX-NT Sport Ready-to-Run, read your engine break-in and operating
instructions. If you run your XXX-NT Sport without following proper break-in procedure, you may dam-
age or fail to get maximum performance from your engine, and void warranty.
NOTE:
1
2
2A
3
4
5

Start your engine
Attach the glow plug ignitor (fig. 6A). Be sure that the “C” size battery is fresh and has power. Put the standard hex of
the starter shaft into the Spin-Start (fig.6B). Slide your hand under the strap of the starter so that your index finger is on
the switch at the bottom. Place the machined end of the starter shaft into the matching hex socket in the back-up.
Caution: If the engine does not turn over, it is probably flooded or the battery in the starter needs to be recharged. Use
a glow plug wrench to loosen the glow plug at least two turns and try again. Raw fuel should come out around the plug.
Tighten the plug and resume starting procedure.
Follow the engine break-in procedure before attempting any racing or high performance operation. Use caution when
adding fuel while the engine is running. Do not over fill or spill fuel outside the tank.
Stopping the engine
To stop the engine, use a rag to cover the exhaust pipe exit(fig. 7A) being EXTREMELY careful not to burn your hand as
this will be hot, or use the handle of a screwdriver (fig. 7B) against the engine flywheel.
6A 6B
7A 7B
If you are having trouble getting started, please see the Troubleshooting Guide.
Customer Support Contacts
Mach .15 and JR Propo Radio Gear
Horizon Hobby Inc.
4105 Fieldstone
Champaign, IL 61821
1-877-504-0233
Team Losi XXX-NT Chassis Compontents
Team Losi
4710 E. Guasti Road
Ontario, CA 91761
[phone] Fax [phone]