TECHLIGHTING Cosmo 18 Wall User manual

1.1
Installation Instructions for
Cosmo 12/18 Wall
700OWCOS_
1
920OWCOSMO
GP I :ENERAL RODUCT NFORMATION
These fixtures are intended to be installed
utilizing compliant junction boxes.NEC
This product may be dimmed with a low-voltage electronic
dimmer or a 0-10V dimmer depending on the wiring
configuration.
Suitable for wet locations.
Install the Fixture
1A
2
1
CAUTION RISK OF FIRE-
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
With the provided Allen wrench, remove the two
mounting plate screws.
Remove the mounting plate from the back of the
fixture.
FIXTURE
SCREW
1
MOUNTING
PLATE
1
ALLEN
WRENCH
OUTDOOR
3
ELECTRICAL BOX
Install the mounting plate onto the electrical box with
the two #8-32 screws provided.
#8-32 SCREW
3
1B
3
#8-32 SCREW

2
7400 Linder Ave, Skokie, 60077IL
847.410.4400
www.techlighting.com
© 2017 Tech Lighting, L.L.C. All rights reserved. The "Tech Lighting" graphic is
a registered trademark of Tech Lighting, L.L.C. Tech Lighting reserves the right
to change specifications for product improvements without notification.
A Generation Brands Company
SAVE THESE INSTRUCTIONS!
1C
Connect the mounting plate ground wire to a suitable
ground in accordance with local electrical codes.
Connect the black fixture wire to the hot power line
wire with a wire nut.
Connect the white fixture wire to the neutral power line
wire with a wire nut.
Use the gray and purple dimming wires for 0-10v
dimming application (if not in use, make sure to cap
these wires off).
Properly place all wires and wire nut connections into
the electrical box.
Mount the fixture by installing it back onto the
mounting plate and reinstalling the fixture screws
(reversal of figure 1A).
4
5
6
7
8
4
5
6
7
9
1D
For wet locations, caulk around the base with
waterproof construction sealant.
10
Warning: The purple and gray wires are only
used for 0-10v dimming. For all other
applications, do not connect the gray and purple
wires.
Note for In-Line Fuse equipped fixtures: in the
case that the fixture is not operating correctly,
make sure to check the fuse.