TechniSat TECHNISTAR S6 Installation and user guide

Please aim the remote control
toward the decoder and operate slowly.
If the decoder fails to respond properly,
we suggest to replace the existing set
of batteries with new ones.
How to re-tune to the new frequency of JSTV HD
TechniSat TECHNISTAR S6
Our frequency has been updated.
If you have a TechniSatTECHNISTARS6, please follow the instructionsbelow to add JSTV HD channels to your decoder.
Number keys
OK
Yellow
Green
MENU
Arrow
OPT
＜＜Buttons you need＞＞
If your decoder is currently connected to the TV with a SCART cable, connecting with a HDMI cable will allow you to watch JSTV with a higher resolution.
Please note that changing cables means you need to choose a different TV input channel such as HDMI 1.

How to remove the old channels
(This procedure will take approximately 5 minutes)
4Move the cursor to JSTV 1 and press the OPT button on your remote control.
A small window on the bottom right side of the screen will appear.
5Select Remove by using the arrow buttons on your remote control and press the OK button to remove
the channel JSTV1.
6
Press the Menu button on your remote control to save your settings and close the menu screen.
It’s all done!
Please repeat step “4” and “5” to remove JSTV2.
Now, the old channels are removed and new channels are set as channel 1 and 2.
1Press the Menu button on your remote control to show the Main menu on your screen.
2Using the arrow button, please select TV list organizer (fourth item on the list) and press the OK button.
3In TV list organizer, make sure the white cursor is on the right side of the screen. If you see the white
cursor on the left side of the screen, use the arrow button to move it to the TV list on the right side.