TECOM Pro-9900 User manual
Page 1
Tecom Pro-9900 Quick Installation Guide
Pro-9900 Quick Installation Guide
TECO Group 「Pro-9900 Portable Vibration Acceptance Instrument」can be applied
in analysis & acceptance of vibration problems for rotary machines. Setup is quick
and easy. Technicians just go thru simple steps with Pro-9900 Auto software running
on tablet to understand potential vibration issues.
It is an essential tool for technicians working in technical support, maintenance, repair
and related fields.
Product contents
b. Tablet Pack x1
–Windows Tablet w/keypro x1
c. Action Pack
(soft case 2 pieces) x1
d. Power Charger
(for Tablet) x1
a. Tool Box : x1
–xDAQ-600 x1
–IEPE Vibration Gauge x1
–Double head screw x1
–Magnet holder x1
–Winding line x1
–Power Bank x1
–Vibration Pole x1
–Power Bank x1
10”Tablet
(with Auto & PMS Software)
Page 2
Tecom Pro-9900 Quick Installation Guide
Quick Settings and Connection
1. Connect the Power Bank to the power jack (DC) of the Smart IoT Gateway xDAQ-
600, and then turn on the Power Bank. The default password of the tablet is
「demo」.
2. After the WAN LED (orange) is on and wait for around 30 seconds. Then search
Wi-Fi AP and start the Wi-Fi connection.
3. On the Tablet, please enter【Wi-Fi】mode to find 【TECOM_XXXXXX】Wi-Fi SSID.
Then, confirm "XXXXXX" 6-digits are exactly the same as the last 6-digits of MAC
address, printed on the serial number label of the Smart IoT Gateway. Select
"TECOM_XXXXXX" for network connection. The Tablet will show “Connected”
to indicate a successful Wi-Fi connection between the Tablet and the Gateway.
This procedure only needs to be done once. The Tablet will automatically connect
to the Gateway after on.
4. Install the magnetic vibration gauge (or w/vibration pole) to the correct position of
the device under measure.
5. After the completion of steps 1 to 4, the Measure and Acceptance procedures by
using Pro-9900 Auto software on Tablet is ready.
This 6-digit number must be the same as the
TECOM_XXXXXX 6-digit number on the Tablet
Wi-Fi network.
Pro-9900
Page 3
Tecom Pro-9900 Quick Installation Guide
Illustration: After opening the toolbox, perform the following steps
1. Connect the Power Back to the 2. Insert keypro into Type C interface
the gateway and wait for about 30
seconds for the gateway to start.
3. Turn on the power on the tablet
4. Find xDAQ-600 Wi-Fi SSID and connect. 5. Select PMS APP to open
Page 4
Tecom Pro-9900 Quick Installation Guide
