Teltonika FMB920 User manual

Teltonika FMB920 GPS TRACKER INSTALLATION GUIDE
Additional configuration
notes if using the device
on our software platform.

NOTES FOR SETTING IGNITION SENSE
There are 3 options for detecting ignition on/off
1. DIN1 Input wire (Yellow) – Connect this wire to a suitable power feed controlled by
vehicle ignition status.
2. Board Voltage – Device automatically detects voltage change when engine is switched
on off and sets the ignition status accordingly. (On some vehicles this feature can provide
false readings such as auto stop start technology etc in which case select option 3
(Movement sense)
3 Movement Sense – When the device detects movement it switched the ignition status to
on. If the device does not sense any movement for any 5 minute period it will switch the
ignition status to off.
You will need to log into the tracking platform to set the method of ignition you
are using.

TRACKING INT RVAL S TTINGS
You can change the data upload settings in
the software platform. If connecting remote
immobilise feature we recommend setting
the ‘idle’ time interval to 30 seconds.
Always ensure you tick the box marked
‘Enable the sleep mode on idle’ which
switches the GPS module off when parked
to preserve the vehicle battery charge level.
UNAUTHORIS D MOV M NT S TUP
The platform will automatically set up
unauthorised movement alerts. To prevent
false alarms from GPS drift we recommend
setting the minimum control start time to 5
minutes and the minimum distance to at
least 1000ft.

HARSH DRI ING MONITOR
You can alter the sensitivity for
the ‘harsh driving’ alerts in the
platform device settings tab.