Teltonika RUT523 User manual

4
Login to device
1. To enter routers Web interface type http://192.168.1.1 in your internet browser.
2. Use the following parameters when prompted for authentication:
User name: admin
Password: admin01
3. Configuration Wizard will start after logging in. It is necessary to complete Configuration
Wizard to setup router to correct mode. You can leave default settings but it is strongly
recommended that you change the password and enable Wireless Security.
4. Go to Status -> Network Information and pay attention to Signal Strength and Signal
Quality. To maximize the performance try adjusting antennas or changing location of your
device to achieve best signal conditions.
This sign on the package means that
it is necessary to read the User’s
Manual before you start using the
device.
This sign on the package means
that all used electronic and electric
equipment should not be mixed
with general household waste.
Please visit our web site www.teltonika.lt for complete user manual
RUT5xx Series
WiMAX Routers
Quick start guide v1.5

2 3
RUT5xx Series
Model
WiMAX Frequency
Ext. USB Modem
RUT523
2.3 –2.4 GHz
RUT525
2.5 –2.7 GHz
RUT535
3.3 –3.6 GHz
RUT538
3.3 –3.8 GHz
RUT523U
2.3 –2.4 GHz
RUT525U
2.5 –2.7 GHz
RUT535U
3.3 –3.6 GHz
RUT538U
3.3 –3.8 GHz
Front Panel
1Power socket
6Power LED
2,3,4 LAN Ethernet ports
7,8,9 LAN LEDs
5WAN Ethernet port
10 WAN LED
Back Panel RUT5xx Back Panel RUT5xxU
1,3 WiMAX antennas connectors
1Wi-Fi antenna connector
2Wi-Fi antenna connector
2Reset button
4Reset button
3WLAN status LED
5WiMAX status LED
4USB socket for WiMAX modem
Hardware installation
1. Attach Wi-Fi and WiMAX antennas, connect USB WiMAX modem (for RUT5xxU).
2. Connect the power adapter to the socket on the front panel of the device. Then plug
the other end of the power adapter into a wall outlet or power strip.
3. Connect to the device wirelessly (SSID: Teltonika) or use Ethernet cable and plug it
into any LAN Ethernet port.
Configure your computer
1. Enable the wireless network connection. (Go to Start > Control Panel > Network and
Internet > Network and Sharing Center. In the left pane click Change adapter settings
link. Right click on Wireless Network Connection and select Enable.
2. Setup wireless network adapter on your
computer (Right click on Wireless Network
Connection select, choose Internet
Protocol Version 4 (TCP/IP) and click
Properties)
3. Select Obtain IP address automatically
and Obtain DNS server address
automatically if they are not selected.
Click OK.
4. Right click on Wireless Network
Connection and select
Connect/Disconnect to see available
wireless networks.
5. Choose the wireless network Teltonika from the list and press Connect.