Teltonika RUT230 User manual

RUT950 LTE Router
CERTIFIED
ORGANISATION
ISO 9001
4LTE is a trade mark of ETSI
Quick start guide v3
This sign on the package means that it
is necessary to read the User's
Manual before you start using the
device.
This sign on the package means that all
used electronic and electric equipment
should not be mixed with general
household waste.
Please visit our web site for more informationwww.teltonika.lt
Hereby, Teltonika declares that this RUT230 is in compliance with the essential requirements
and other relevant provisions of Directive 1999/5/EC.
Login to device
1. To enter router's Web interface type in your internet browser.http://192.168.1.1
2. Use the following parameters when prompted for authentication:
3. Configuration Wizard will start after logging in. It is necessary to complete Configuration Wizard to
setup router to correct mode. You can leave default settings but it is strongly recommended that you change
the password and enable Wireless Security.
4. Go to Status > Network and pay attention to Signal Strength. To maximize the performance try adjusting
antennas or changing location of your device to achieve best signal conditions.
LAN OpenVPN
860461024004296
-44 dBm
OK

23
2. Attach LTE and WiFi antennas.
3. Connect the power adapter to the socket on the front panel of the device. Then plug the other end of the
power adapter in to a wall outlet or power strip.
4. Connect to the device wirelessly (SSID: Teltonika_Router) or use Ethernet cable and plug it in to any
LAN Ethernet port.
SIM1 (primary) SIM2 (secondary)
Front panel Back panel
1, 2, 3 LAN Ethernet ports
4 WAN Ethernet port
5, 6, 7 LAN LEDs
8 WAN LED
9 Power socket
10 Power LED
11 GSM connection status LED
12 GSM signal strength indication LEDs
1, 2 LTE antenna connectors
3, 5 WiFi antenna connectors
4 Reset button
Hardware installation
1. Remove back panel and insert SIM cards which were given by your ISP (Internet Service Provider).
Correct SIM cards’ orientation is shown in the picture.
Configure your computer (using Windows)
Enable the wireless network connection
( o to Start > Control Panel > Network g
and Internet > Network and Sharing
Center. In the left panel click Change
adapter settings link. Right click on
Wireless Network Connection and
select Enable).
1
2Setup wireless network adapter on your
computer ( ight click on Wireless r
Network C onnection a nd s e l e c t
Properties. After that select Internet
Protocol Version 4 (TCP/IP) and click
Properties).
Choo se the wire les s ne two r k
Teltonika_Router from the list and
click Connect.
3S e l e c t O b t a i n I P a d d r e s s
automatically and Obtain DNS
server address automatically if
they are not selected. Click OK.
Right click on Wireless Network
C o n n e c t i o n a n d s e l e c t
C o n n e c t / D i s c o n n e c t t o s e e
available wireless networks.
4
5
Teltonika_Router
21
1211
10
9
8
7
6
5
4
3
54
3
2
1