Tennant 6500 Training manual

IB 340542 (7-02) 1
No. 340542
Machine: 6500
Published: 7-02
Rev. 00
INSTRUCTION BULLETIN
NOTE: DO NOT DISCARD the Parts List from the Instruction Bulletin. Place the Parts
List in the appropriate place in your machine manual for future reference.
Retaining the Parts List will make it easier to reorder individual parts and will
save you the cost of ordering an entire kit.
NOTE: Numbers in parenthesis ( ) are reference numbers for parts listed in Bill of Materials.
Installation instructions for kit number 383265
DESCRIPTION:
This kit contains the parts needed to replace the main brush lift handle on the model 6500
sweeper.
Please follow step-by-step instructions.
SPECIAL TOOLS / CONSIDERATIONS: None
(Estimated time to complete: 1 hour)
PREPARATION:
FOR SAFETY: Before leaving or servicing machine, stop on level surface and set parking
brake. Then turn off machine and remove key.
INSTALLATION:
1. Remove and set aside access plate 383189
and mounting hardware from the operator’s
compartment.
2. Disconnect the main brush lift cable 383194
from lift lever 383150.
383189
383150
383194

IB 340542 (7-02)2
3. Disconnect lift lever 383150 from the machine. Set the
mounting hardware aside.
4. Remove and set aside the star knob 383205 and
brush adjustment plate 383201 from the machine.
5. Remove and discard the main brush panel 383215
and lift handle seal 383196.
6. Mount the new lift lever (1) to the machine with spacer
363087, thrust washer 07450, flat washer 32492 and
hex screw 69225.
NOTE: Apply blue Loctite to the hex screw threads before
installing the new lift lever.
Torque the hex screw to 35--49 Nm (25--35 ft. lbs).
383150
383205 383201
383215
383196
1

IB 340542 (7-02) 3
7. Connect the main brush lift cable 383194 to the
new lift lever (1) with set aside mounting hardware.
8. Replace access plate 383189 in the operator’s
compartment with set aside mounting hardware.
9. Install new main brush panel (2) with set aside
mounting hardware. Replace star knob 383205
and brush adjustment plate 383201 on the machine.
10.Start the machine and check the new main
brush lift lever (1) for proper operation.
BILL OF MATERIALS FOR ROUND BRUSH LIFT HANDLE KIT 383265
TENNANT
Ref. Part No. Description Qty.
1 383258 Lever wldt, brush lift 1
2 383263 Panel assy, main brush w/ label 1
TENNANT COMPANY
P. O. Box 1452
Minneapolis, MN 55440-1452
1
383189
2