Tennant 9016975 Training manual

IB 9016977 (02- 2019) 1
INSTRUCTION BULLETIN
No. 9016977
Machine: T16
Published: 02- 2019
Rev. 00
NOTE: DO NOT DISCARD the Parts List from the Instruction Bulletin. Place the
Parts List in the appropriate place in the machine manual for future
reference. Retaining the Parts List will make it easier to reorder
individual parts and will save the cost of ordering an entire kit.
NOTE: Numbers in parenthesis ( ) are reference numbers for parts listed in Bill of Materials.
Installation instructions for kit number 9016975
SYNOPSIS:
This kit contains the parts needed to replace side brush cable keeper angle on T16 scrubbers.
Please follow step-by-step instructions.
SPECIAL TOOLS / CONSIDERATIONS: NONE
(Estimated time to complete: 45 minutes)
PROTECT THE ENVIRONMENT
Please dispose of packaging materials, used machine components
such as batteries and fluids in an environmentally safe way according
to local waste disposal regulations.
Always remember to recycle.
PREPARATION:
FOR SAFETY: Before leaving or servicing
machine, stop on level surface, turn off
machine, and remove key.
INSTALLATION:
1. Use two M5 hex screws (2), two flat washers
(3), and two M5 hex nuts (4) to install each
cable keeper spacer (5) onto the cable keeper
angle (1). Torque hardware to 4.5- 5.5 Nm
(3.32- 4.10 ft. lbs). (Fig. 1)
2. Disconnect the side brush cable from the side
brush mounting bracket to remove tension
from the cable keeper angle assembly.
(Fig. 2)
3. Remove the existing cable keeper angle from
the machine. Set all hardware, spacers, and
the sheave aside. Discard the cable keeper
angle. (Fig. 2)
4. Apply a light coat of Loctite243tBlue
Threadlocker onto the threads of the saved
M8 screw.
Loctite243tare registered trademarks of the Henkel Corporation
1
2
3
4
5
5
4
3
2
FIG. 1

IB 9016977 (02- 2019)2
5. Use the M8 screw from the previous step and
remaining saved hardware to install the
sheave, spacers, and the new cable keeper
angle (1) onto the side brush mounting
bracket. Torque hardware to 16- 21 Nm
(11.80- 15.50 ft. lbs). (Fig. 2)
6. Reconnect the side brush cable to the side
brush mounting bracket. (Fig. 2)
7. Start and test the machine. Raise and lower
the side brush and observe the newly installed
cable keeper angle assembly. The cable
keeper spacers (5) on the cable keeper angle
(1) should not touch the sheave. The side
brush should move smoothly with no binding
when raised and lowered.
FRONT
Remove and discard
existing cable keeper
angle. Replace with new
cable keeper angle (1)
Set hardware,
both spacers, and
sheave* aside
Actuator
Side brush
mounting bracket
Side brush cable*
*NOTE: Check both the side brush cable and the
sheave for damage. Order a new side brush
cable and/or sheave if these items are damaged.
FIG. 2
Bill Of Materials For Cable Keeper Kit, Side Brush - 9016975
Ref.
Tennant
Part No. Description Qty.
11234781 Angle, Keeper, Cable 1
2 1228033 Screw, Hex, M5 X 0.80 X 30, SS 2
3 01683 Washer, Flat, 10, SS 2
4 09739 Nut, Hex, Lock, M5 X 0.80, NL, SS 2
51234827 Spacer, Cable Keeper 2
TENNANT COMPANY
P. O. Box 1452
Minneapolis, MN 55440-1452