This product should only be used on firm, level ground.
Keep small parts out of reach of children.
Unwrap all packaging materials and place the components
on top of the carton box or on a clean floor to prevent it from
scratching.
Check the pack and make sure you have all the parts listed.
Make sure the legs remain in contact with the ground.
We recommend the use of furniture covers to protect your
product when not in use.
During bad weather and winter months the product should be
stored in a cool dry place. Before storage ensure that it is
clean and dry.
Do not use power tools to construct this product..
Do not tighten screws until fully assembled.
Do not over tighten screws or bolts.
Do not use this product if parts are missing, damaged or worn.
Do not sit or stand on the product.
Never use a pressure hose or washer to clean the product.
Never use scourers, abrasives or chemical cleaners.
“Hi, look out for me throughout this manual. Wherever you
see my picture I will have a handy tip to help you with the
assembly of your product.”
My first tip is:”Before you start get a cup of tea, sit down and
read though these instructions carefully.”
And for good measure my second tip is that you will need the
following tools to assemble this product, so gather them to
hand before you start.
2
Check all screws or bolts are tightened and inspect regularly.
To clean wipe with a sponge and warm soapy water then
wipe with a dry, clean cloth.
Ensure that this product is fully assembled as illustrated
before use.
If a glass component is chipped or broken, stop using the
Produced in China for TESCO Stores Ltd.
©Tesco 2014.
Marrakech 4pc Lounge Set-Table
Assembly instructions
product and consult the manufacturer or supplier
Do not place very hot or very cold items on the glass surface(s)
unless adequately thick table mats are used to prevent such
items coming into contact with the glass.
Do not sit or stand upon the glass surface.
Do not use the glass as a chopping surface. Do not strike the
glass with hard or pointed items.
The glass of this product complies with BS EN 12150-1:2000
When you are ready to start, make sure that you have the
right tools, plenty of sapce and a clean, dry area for assembly.
Important:
RETAIN FOR FUTURE REFERENCE: READ CAREFULLY
Two people to assemble and lift the table into position.
15 minutes
clause 8
The frames are manufactured using the powder coated steel
tubing. When steel is exposed to air and moisture it will rust.
Any scratches on the paintwork should be touched up
immediately with metal paint, otherwise corrosion may occur.
This product is intended for a maximum weight of 75 kg.
Do not exceed this weight