Test Equipment Depot 89088 User manual

INSTRUCTION MANUAL
MINI TYPE
THERMO-ANEMOMETER
Test Equipment Depot - 800.517.8431
99 Washington Street Melrose, MA 02176
TestEquipmentDepot.com

INTRODUCTION
FEATURES
1.
Congratulations on your purchase of the
unique mini Anemo Thermometer.
The meter features big display of Air
Velocity and Temperature, simple and
easy to operate, 7 units of scale to be
selected .
A pocket design makes it convenient and
portable, easy to use and to get an
accurate reading.
INTRODUCTION
This package contains:
The meter x 1
CR2032 battery x 1
Operation manual x 1
Wrist strap x 1
Plain box x 1
Pouch x 1
Temp./Windchill :Averaging & LCD
display is updated every second.
Windspeed :Moving 2 sec average
with maximum 2 second average.
LCD is updated every second.
Temperature sensor :Sealed
precision thermister.
Shock proof housing.
One button data hold operation.
Records maximum reading.
o o
Unit C/ F switchable.
Replaceable lithium battery.
6different windspeed units selectable.
Safety wrist strap makes it carry
around and avoids falling down.

Power off
Power Supply
Air velocity range & Res.
Air velocity accuracy
Dimension
Impeller Dia.
Unit in Imperial
Unit in Metric
Unit
SPECIFICATION
Automatic shut off
after 5 minutes
CR2032 battery x 1
0.5~44.7 M/H (0.1)
60~3937 FT/M (2)
130 x 43.5 x 16mm
KNT, BF
oC , M/S, KMH
OF , FT/M, M/H
0.4~38.8 KNT (0.1)
1.1~20.0 M/S (0.1)
0.8~72.0 KMH (0.1)
1~8 Beaufort (1)
Temperature range & Res.
o
0~50 C (0.1)
o
32~122 F (0.1)
Temperature accuracy
Battery Life 48 hours
(continuous use)
meter per second
Feet per minute
Knot
M/S
FT/M
KNT
KMH
M/H
BF
NOTE:
24mm
Kilometer per hour
Beaufort
Mile per hour
Air velocity display
Update every second.
Response time: 1 min
Temperature response
LCD update every sec.
and display every 2
second average.
3.
+5% or + last
significant digit
(whichever is greater)
o o
+1 C (+2 F)

9.
CAUTION
NOTE:
The meter is accurate at low and mid
range air speeds. Consistent use at very
high speeds., ie, From the window of a
fast moving car will damage the impeller’s
bearing and reduce accuracy.
NOTE:
When you program the meter and then
restart the meter, it will default to the last
mode (except the sleep mode) and unit
used.
NOTE:
You can remove the transparent protection
film of the LCD if you feel the display is
blurred.
.TROUBLE SHOOTING
1. Power on but no display
a) Make sure the time of pressing
key is > 0.1 second.
B )Check the batteries are in place with
good contact & correct polarity.
c) Replace battery or move away the
battery for one minute and re install.
2. Display disappear
a) Replace a new battery.
b) Disable the auto power off function
before power on for long time using.
3. Err
The temp. related components or circuit
is damaged. Sent back for repair.
5. Windspeed reading is always zero
The windspeed components or circuit
is damaged. Sent back for repair
4. HI
The windspeed is higher than 44.7M/H