Recording the image
1Freeze image: Press trigger button ➁once.
2Save image: Press trigger button again.
or
Discard image: Press [Esc] ➀.
Getting to know the menu
1Open menu: Press [OK] ➀.
2Navigate: Move Joystick ➀up / down.
3Open submenu (only for menu points marked
with ): Move joystick to the right.
4Call up a function: Press [OK].
or
Exit menu: Press [Esc] ➁.
Focusing the picture
❯Turn lens ➀by hand.
Switching on / off
❯Remove protection cap ➀from the lens.
❯Switch on: Press [ ] ➁.
- The measurement view is opened after the warm-
up period.
- The thermal imager performs an automatic
zeroing approx. every 60 sec. This can be
recognized by a “click”. The image is frozen
briefly when this occurs.
❯Switch off: Press [ ] again.
➆
➅
➂
➃
Apply
➄
➁
➀
➀
➁
➀
➀
➁
➀
➁
Measurement
Image gallery
Scale...
Display...
Emissivity...
Palette
Configuration
Commissioning
1Push the rechargeable battery ➀all the way
into the rechargeable battery slot until this is flush
with the bottom of the handle.
- The thermal imager starts automatically.
2Remove protective film from the display ➁.
- Instrument language (Language) and temperature
unit (Unit) can be set:
3Move Joystick ➂up / down to select the desired
option.
4Press [OK] ➂.
5Move Joystick up / down to change the setting.
6Press [OK].
7Press [Apply] ➃function key to apply the
settings.
8Press []➄ to switch off the thermal imager.
9Connect mains unit ()➅.
10 Completely charge battery (3 hours).
11 Insert Memory card in the card slot (SD) ➆.
- The camera is now ready for operation.
