The Handy THLSS-B Installation and maintenance instructions

OPERATOR’S MANUAL AND PARTS LIST
Log Splitter Stand - THLSS-B
Spares & Support: 01793 333212
www.thehandy.co.uk
Before use please read & understand this manual, paying particular
attention to the safety instructions.
13/02/2012

Log S litter Stand-THLSS-B
This stand is roduced to su ort The Handy Log s litter THLS-B
Thank you for purchasing The Handy log splitter stand. Please carefully read the
assembly instructions for the safety of yourself and the persons around you.
PRODUCT SP CIFICATION
Measure: 74x64x70cm
Net Weight: 9.5kg
Gross Weight: 10kg
Check the com onents according to the following lists Fig 1 and Fig 2:
A. Main upright support leg — top section fixing point for the log splitter THLS-B
B. Horizontal bar
C. Horizontal bar
D. Top horizontal end support bar (the two feet under the electric motor on the log
splitter THLS-B are secured to the centre of this part)
. Leg Support
F. Leg Support
G. Axle and wheels with centre mounting bracket and two outer mounting brackets
Fig 1.

Parts List and Diagram
Fig 2.
No Name Qty
1 Main upright support leg 1
2 Horizontal bar 1
3 Horizontal bar 1
4 Screw (M8 X 100) 1
4-1 Nut (M8) 1
5 Screw(M8 X 16) 8
6 Stand fixing for electrical motor 1
7 Screw(M8 X 50) 2
8 Axle and wheels 1
9 Leg Support 1
10 Leg Support 1

Stand Assembly - As Per Fig 3.
Using the parts and fixings supplied assemble as follows:
1. Pass part C through the centre mounting bracket on part G
2. Connect parts E and F to the outer mounting brackets on parts G
3. Connect part D to E and F
4. Connect part B to D
5. Connect part A to B and C
6. Loosly tighten all fixing bolts. Do not tighten completely at this stage, as
some movement may be required when fitting the log splitter to the stand.
Fig 3.

Remove the supporting foot (part 22) on your log splitter THLS-B as shown in
Fig 4. (Please keep these parts safe for future use). Remove the nut and bolt
(4 and 4.1 Fig 2) from the main upright support leg A. Carefully lower the log
splitter into place on the stand as shown in Fig 5. Refit the nut and bolt (4 and
4.1) at the top of upright A. **Using the two screws (7 Fig 2) from the
underside, screw them through part D into the motor support feet to secure
the log splitter into place.
**Note: Please check that the holes in the two feet under the electric motor
are clean and remove any debris or dirt before fitting.
Check that all fittings and fixing points are secure before starting work.
Fig 4.
Fig 5.

To order spare parts and see the complete range of garden
machinery and garden equipment from Handy, visit:
www.thehandy.co.uk
Spares & Support: 01793 333212