The Handy THLSS-B User manual

Assembly Instructions
THLSS-B
Please carefully read the assembly instructions before starting work.
Sales and Helpline: 01793 333220

Log Splitter Stand-THLSS-B
This stand is produced to support The Handy Log splitter THLS-B
Thank you for purchasing The Handy log splitter stand. Please carefully read the
assembly instructions for the safety of yourself and the persons around you.
PRODUCT SPECIFICATION
Measure: 74x64x70cm
Net Weight: 9.5kg
Gross Weight: 10kg
ASSEMBLY:
Fig 1: List of components
Check the components according to the following list and Figure 1.
A. Main upright support leg
— top section fixing point for the log splitter THLS-B
B. Horizontal bars
C. Horizontal bars
D. Stand fixing bar for the electrical motor of the log splitter THLS-B
E. Leg Supports
F. Leg Supports
G. Axle and wheels
Fig 1

Parts List and diagram
Fig 2.
No Name Qty
1 Main upright support leg 1
2 Horizontal bars 1
3 Horizontal bars 1
4Screw (M8 X 90) 1
4-1 Nut (M8) 1
5 Screw(M8 X 15) 8
6 Stand fixing for electrical motor 1
7 Screw(M8 X 50) 2
8 Axle and wheels 1
9 Leg Supports 1
10 Leg Supports 1

Change the first sentence as follows. Remove all the parts from the carton and check against the
parts list.
Assemble the parts as figure 3.
Connect part B with parts A and part D by screw (M8 x 15),
Connect part C with parts A and part G by screw (M8 x 15)
Connect part E with parts G and part D by screw (M 8 x 15),
Connect parts F with parts G and part D by screw (M8 x 15).
Ensure that all the fixing points tight and secure.
Fig 3

Assembled Log Splitter stand THLSS-B with The Handy Log splitter THLS-B
Carefully fit the log splitter to your fully assembled stand, use the screws and nut supplied (part
list items 4-1 & 7, M8 X 50 & M8) to secure the log splitter to the stand.
Secure your log splitter at points A ( top section of the main support leg) and D.
Ensure all fixing points are tight and secure.