The Shann Group URBAN TRACK Installation guide

URBAN TRACK
CARE INSTRUCTIONS
Contact us:
Melbourne
03 8480 0800
Sydney
02 9832 7000
Brisbane
07 3808 7277
Adelaide
08 8277 7733
Perth
08 9244 4433
Auckland
09 820 0780
www.theshanngroup.com

Retractable Blinds
• Always operate blinds from centre.
• When retracting your blind, place both hands in the middle of the
bottom bar to ensure it retracts evenly.
• Retractable blinds may be difficult to operate in windy conditions
(you may need to apply pressure to the centre of the mesh to help
the blind up).
Electronic Blinds
• Avoid operation in high winds.
• Always supervise electronic blinds when in operation.
• Motorised blinds will not operate in a power outage (there is no
manual override).
• Do not try and alter pre set selections on remote.
• Use selection button to select which blind to operate (if help is
required, contact your installer)
Maintenance
• As blinds have been rolled up for transport, they will need to be left
down for 48 hours to allow material to settle (unless high winds are
predicted).
• Blinds must be fully retracted into pelmet in severe weather
(not doing so will void your warranty).
• Use silicone lubricant to lubricate
track if you find tracks are sticky,
or as required (never use oil based
lubricants).
• Use soapy water and a hose
to clean blinds.
• Do not use chemicals on or
near blinds.
• Keep blinds clean for longer in
service life.
URBAN TRACK
CARE INSTRUCTIONS
Remote Control
Features
Selection
Up
Hold/Centre
Down