Tiger Electronics LAZER TAG Deluxe 2 Player System 71094 User manual

®
™
*
AGES 8+
71094
Deluxe 2 Player System
Tiger®* recommends
ENERGIZER® batteries for
ideal performance.
CAUTION:
Do not look directly at the sun.
NOTE: Not for nighttime play.
Thank you for purchasing the LAZER TAG Deluxe 2 Player System. Please be
sure to read and follow all instructions carefully before using this product.
Includes 1 Green Tagger™* Unit, 1 Green HUD™* Unit, 1 Orange Tagger™* Unit, 1
Orange HUD™* Unit, 2 Connector Cables, Stickers & Instructions.
Each Tagger™* Unit requires 6 x 1.5V “AA” or R6 size batteries (not included).
Alkaline batteries recommended. Phillips/cross head screwdriver (not included)
needed to insert batteries.
FIND 6 HIDDEN LAZER TAG [CODES]
THROUGHOUT THIS BOOK.
Log-on to lazertag.com and enter your
codes to unlock secret bonus game
strategies!

Quick Start Guide..........................................................................1
Introduction.....................................................................................2
Battery Installation Information................................................3
Tagger™* Unit Illustration...........................................................4
TAGGER Buttons.............................................................................5
LCD Screen......................................................................................5
HUD™* (HEADS UP DISPLAY) UNIT Illustration.....................6
How to Connect your TAGGER to the
HUD (HEADS UP DISPLAY) ..........................................................7
To Wear the HUD...........................................................................8
Lazer Tag® Code Of Conduct.....................................................8
Lazer Tag® Game Features ........................................................9
Medic Mode...................................................................................11
Programmable Games................................................................12
How to Host a Game..................................................................13
How to Join a Game ...................................................................15
End of Game Debriefing and Scoring.....................................16
TABLE OF CONTENTS
Ending Games Early ....................................................................17
11 Pre-Programmed Games......................................................18
Classic Lazer Tag®/Custom Lazer Tag® ..............................18
2 and 3 Team Custom Lazer Tag®.........................................18
Hide and Seek ..............................................................................19
Hunt the Prey...............................................................................20
2 and 3 Kings...............................................................................20
Zone Games ..................................................................................21
Own the Zone ...............................................................................22
Energizer Coupon.........................................................................23
2 and 3 Teams Own the Zone .................................................25

For a quick, “Grab & Go” game of Lazer Tag®, simply follow these steps:
1. Press the TRIGGER to wake your Tagger™*Unit up.
2. Verify that the power-up SFX are played, and “LTAG” appears on the LCD
screen.
3. Press the TRIGGER to start the Classic LAZER TAG “LTAG” game. All players
should press their triggers together, so that everybody starts at the same time.
4. The LCD Screen will display a 10-second countdown during which time the
players should take their desired positions.
5. At T-0 the TAGGER will say “GOOD LUCK” and the game will begin.
6. Aim and get tagging!
The Classic LAZER TAG game is an “individuals” game, which means that
all other players are your opponents. The winner is the last player not
tagged out. Each player has unlimited reloads, 10 Mega-Tags, 15 seconds
of shields, and is tagged out after receiving 10 tags from other players.
After a player is tagged out, their Game Time will continue to run for
another 2 minutes and the number of minutes and seconds which they
lasted before being tagged out will be shown below the Game Time. Any
player who has cheated by restarting their TAGGER in mid-game will have
a much lower Game Time than anyone else, so players can check each
others’ timers to ensure no player has done this.
A TAGGER will go to sleep if there is no activity for two minutes after
being tagged out. To maintain your game timer longer than this, press OK
once a minute or so until the game is over for all players, then you can
compare timers.
Classic LAZER TAG is not a Hosted game, so it does not require Hosting
and Joining the way the other more advanced games do. It also does not
support Debriefing and Scoring at the end of the game.
QUICK START GUIDE
For a quick, “Grab & Go” game of Lazer Tag®, simply follow these steps:
1. Press the TRIGGER to wake your Tagger™*Unit up.
2. Verify that the power-up SFX are played, and “LTAG” appears on the LCD
screen.
3. Press the TRIGGER to start the Classic LAZER TAG “LTAG” game. All players
should press their triggers together, so that everybody starts at the same time.
4. The LCD Screen will display a 10-second countdown during which time the
players should take their desired positions.
5. At T-0 the TAGGER will say “GOOD LUCK” and the game will begin.
6. Aim and get tagging!
The Classic LAZER TAG game is an “individuals” game, which means that
all other players are your opponents. The winner is the last player not
tagged out. Each player has unlimited reloads, 10 Mega-Tags, 15 seconds
of shields, and is tagged out after receiving 10 tags from other players.
After a player is tagged out, their Game Time will continue to run for
another 2 minutes and the number of minutes and seconds which they
lasted before being tagged out will be shown below the Game Time. Any
player who has cheated by restarting their TAGGER in mid-game will have
a much lower Game Time than anyone else, so players can check each
others’ timers to ensure no player has done this.
A TAGGER will go to sleep if there is no activity for two minutes after
being tagged out. To maintain your game timer longer than this, press OK
once a minute or so until the game is over for all players, then you can
compare timers.
Classic LAZER TAG is not a Hosted game, so it does not require Hosting
and Joining the way the other more advanced games do. It also does not
support Debriefing and Scoring at the end of the game.
QUICK START GUIDE
" "
1

Thank you for purchasing the Lazer Tag® Deluxe 2 Player
System! Step into LAZER TAG – where video game action
comes to life!™* LAZER TAG combines extreme team
competition with hi-tech accuracy. Assemble your team and
lead them into The Ultimate Game of Electronic Tag™* to
become the Tag Master™*!
Please be sure to read and follow all instructions carefully
before using this product. Before you can begin playing
with your LAZER TAG Deluxe 2 Player System you must
first install batteries.
Be the TAG MASTER!
Think you’ve got what it takes to be the TAG MASTER?
Prove it by being the winner in your first game of LAZER
TAG! Earn this title and you will have the privileges of
being the host for every game!
Thank you for purchasing the Lazer Tag® Deluxe 2 Player
System! Step into LAZER TAG – where video game action
comes to life!™* LAZER TAG combines extreme team
competition with hi-tech accuracy. Assemble your team and
lead them into The Ultimate Game of Electronic Tag™* to
become the Tag Master™*!
Please be sure to read and follow all instructions carefully
before using this product. Before you can begin playing
with your LAZER TAG Deluxe 2 Player System you must
first install batteries.
Be the TAG MASTER!
Think you’ve got what it takes to be the TAG MASTER?
Prove it by being the winner in your first game of LAZER
TAG! Earn this title and you will have the privileges of
being the host for every game!
2

Using a Phillips/cross
head screwdriver, loosen
the screw in the battery
compartment cover of
each TAGGER (screw stays
attached to cover). Remove
cover. Insert 6 x “AA”/R6
alkaline batteries. Replace
cover and tighten screw.
TO INSERT BATTERIES
IMPORTANT: BATTERY INFORMATION
Please retain this information for future reference.
Batteries should be replaced by an adult.
CAUTION:
1. Always follow the instructions carefully. Use only
batteries specified and be sure to insert item correctly
by matching the + and – polarity markings.
2. Do not mix old batteries and new batteries or standard
(carbon-zinc) with alkaline batteries.
3. Remove exhausted or dead batteries from the product.
4. Remove batteries if product is not to be played with for
a long time.
5. Do not short circuit the supply terminals.
6. Should this product cause, or be affected by, local
electrical interference, move it away from other
electrical equipment. Reset (switching off and back on
again or removing and re-inserting batteries)
if necessary.
7. RECHARGEABLE BATTERIES: Do not mix these with any
other types of battery. Always remove from the product
before recharging. Recharge batteries under adult
supervision. DO NOT RECHARGE OTHER TYPES OF
BATTERIES.
CAUTION: TO AVOID BATTERY LEAKAGE
1. Be sure to insert the batteries correctly and
always follow the toy and battery manufacturers’
instructions;
2. Do not mix old and new batteries or alkaline,
standard (carbon-zinc) or rechargeable (nickel-
cadmium) batteries;
3. Always remove weak or dead batteries from
the product.
3

TAGGER RIGHT SIDE
TAGGER LEFT SIDE
TAGGER REAR VIEW
HUD (HEADS UP DISPLAY)
Shield Button
Launching Tube
Receiving Tube
4
LCD Screen
Increase/ +10 Button
Decrease/ -10 Button
Cancel/ Sleep Button
2ndF Button
Display/Contrast
Button
Reset Button
Battery Door
Reload
Lever
Indoor/Outdoor
Switch
TAGGER Speaker Switch
(On/Off)
Trigger
Speaker
Accessory
Track
IFF Beacon and Receiver Dome
Sight
Sight
OK Button
Accessory
Track
HUD (Heads
Up Display)
Brightness Slide
Switch
Function
Button

The following buttons are used to enter information into your
TAGGER before, during, and after the game. Each button has two
functions: its Main Function and its Second Function.
2ndF: Hold this button down and quickly press then release any
of the other buttons to perform that button’s Second Function.
Pressing and holding 2ndF for more than 2 seconds at any time
during an actual game mutes or un-mutes the sound effects.
INC: Selects the next item in a list of options, or increases a
number value by 1. Second Function: 2ndF + INC = Increases the
number value by 10.
DEC: Selects the previous item in a list of options, or decreases
a number value by 1. Second Function: 2ndF + DEC = Decreases
the number value by 10.
OK: Enters the selected option or value. Second Function: Starts
or ends the game immediately (only the Host can do this).
CANCEL: Cancels the value or option just selected and backs-
up a step, or dismisses Medic-Mode requests. Second Function:
2ndF + CANCEL = Quits the game and turns the TAGGER off.
DISPLAY: Selects which set of data is to be displayed during
BUTTONS
the game. Second Function: 2ndF + DISPLAY = Adjusts the
LCD contrast.
FUNCTION: Selects the special modes for the Trigger and the
Shield. Holding this button while pulling the Trigger adds Mega-
Tag power to the next tag that you launch. Holding this button
while pulling the Shield initiates Medic Mode.
INDOOR/OUTDOOR SWITCH: Decreases the intensity of
the tag signal for use indoors so that you don’t accidentally
“splatter” your teammates with reflecting tags.
LCD SCREEN
VISUAL CONFIRMATION SYMBOLS
Flashes when you are tagged by another player.
Flashes when you tag another player.
Flashes when your TAGGER is aimed directly at
another player.
Displays when there is an opposing player
nearby.
5

HUD (HEADS UP DISPLAY)
Flashes when you are tagged by
another player.
Flashes when your TAGGER is
aimed directly at another player.
Flashes when you tag another
player.
VISUAL CONFIRMATION SYMBOLS:
1. Alert Icons (Tagged, Locked-On, Scored, Danger)
2. Alpha-Numeric Display (Instruction, Game Type, Time, Warnings)
3. Multipurpose Bar Graphs (Ammo, Tags)
4. Reconfigurable Numeric Display (Team, Player, Ammo,
Shields, Tags)
1 2
3 34
6
Adjustable strap
Eyepiece
[visual feedback]
Earpiece
[audio feedback]
Optical Projector
Connector
Red
Yellow
Green

TO HOOK UP THE TAGGER TO THE HUD (HEADS UP DISPLAY) HEADSET SYSTEM
Plug this end of the Connector Cable into the HUD
(HEADS UP DISPLAY) Cable Port.
Plug this end of the
Connector Cable into the
HUD port on the TAGGER.
STICKERS
Several stickers have been included for you to decorate your
TAGGER. Please apply the stickers anywhere you like on your
TAGGER with the exception of the: LCD screen, IFF Beacon/
Receiver Dome and the Launching and Receiving Tubes.
NOTE: Stickers are a one-time application.
Do not place stickers where arrows are indicating.
PLEASE NOTE: Do not cover HUD lenses with stickers.
HUD Unit
Cable Port
Rumble Pack
Port
7

TO WEAR THE HUD (HEADS UP DISPLAY)
HEADSET SYSTEM
1. Wake up the TAGGER by pressing the TRIGGER.
2. Put the HUD (HEADS UP DISPLAY) HEADSET on over your head,
similar to putting on a pair of sunglasses. Take the right side of
the headband, and stretch it across the back of you head, and
loop it through the holder on the left side. Pull the headband
tight to the back of your head and fasten by pressing down
firmly. Adjust the strap on the back of your head so that the
headset is firmly in place. Make sure the HUD (HEADS UP
DISPLAY) OPTICAL PROJECTOR is on your right side, and that you
can see clearly through the lenses.
3. Move the OPTICAL PROJECTOR to position the EYEPIECE so that
you can clearly see your Visual Confirmation Symbols.
4. Adjust the brightness of the Visual Confirmation Symbols using
the DISPLAY BRIGHTNESS SLIDE SWITCH.
NOTE: The TAGGER will function properly without the HUD (HEADS
UP DISPLAY) attached.
LAZER TAG Players follow a strict code of conduct when playing
LAZER TAG. The following is the Official LAZER TAG Code Of
Conduct that should be strictly adhered to in every game of
LAZER TAG.
Rule 1: LAZER TAG is a non-contact sport
This means no physical contact between you and other
players – EVER!
Rule 2: No covering the Receiver Dome
This means do not use anything to cover up the Receiver Dome
thereby preventing you from receiving tags. If you want to avoid
being tagged, you must use your defensive shields or take cover
behind something.
Rule 3: Equipment Failure means Disqualification
In the event that your TAGGER fails to work, you are disqualified
and must wait until the end of the game to join the next one.
Please check your TAGGER and HUD (HEADS UP DISPLAY)
carefully before entering a game to ensure that it is working
properly.
Rule 4: LAZER TAG is a Game
Players must remember that LAZER TAG is only a game. It is
designed purely for recreational use and for fun. Not having fun
is against the code.
LAZER TAG® CODE OF CONDUCT
8