Timex 536 User manual

I N
MAX
MIN
OUT
MAX
MIN
CH1
CH2
CH3
R
2. Receiver:
INSTRUCTION MANUAL
MODEL 536, 31638 WIRELESSTHERMOMETER
I N
OUT
And then.
FEATURES:
I N
OUT
CH1
Place 2 AAA batteries into the
battery compartment, the
display will show.
A. MODE To switch or
B. CHANNEL: Press CHANNEL
key once, display shows.
I N
OUT
CH3
I N
OUT
I N
OUT
I N
OUT
Press CHANNEL key to choose
the preferred channels from 1-3.
C. MAX/MIN: To show indoor/
outdoor maximum/minimum
temperature press MAX/MIN
key. Hold it for 2 seconds, to
cleanthe recordof maximum
and minimum temperature.
D. RESET Press RESET k e y o n
the back, to reset the unit.
E. Temperature trend:
Temperature is falling.
The unit is searching and
showing outdoor temperature
for channels from 1-3
automatically and consecutively.
If there's no outdoor sensor in
the channel, the outdoor
temperature will show blank
Press CHANNEL key 3 more
times, display shows.
,,
,,
1. Batteries required:
Receiver: 2 - AAA
Transmitter: 2 - AAA

F. Low Battery Indication:
I N
OUT
I N
OUT
Low battery for receiver
Low battery for transmitter
I N
OUT
G. Data Receiving Indication
3. Transmitter:
(Back View)
TX RESET 1 2 3
AAA 1.5V
AAA 1.5V
A.TX: Press this key, to manually send signals to
receiver for testing.
B.RESET: To reset the trabsmitter.
C.1 2 3: channels from 1-3. If switched on 1, the
receiver will show CH1 for outdoor temperature.
A maximum 3 transmitters could be used to
monitor outdoor temperatures. The TX6360
comes with only one transmitter.
Additional transmitters can be purchased from
Maverick Industries, Inc. for $7.50/ea plus $6.25
shipping and handling. Mail checks and request
for TX6360 TRANSMITTER to:
Maverick Customer Service
94 Mayfield Ave.
Edison NJ 08837
Use a small Phillips head screw driver to unscrew
the battery compartment and insert 2 AAA batteries.
FCC STATEMENT
1.This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference
that may cause undesired operation.
2. Changes or modifications not expressly approved by the party responsible
for compliance could void the user s authority to operate the equipment.