TMI Products VK83 User manual

Version-01
Cal.VK83A
*3
*2 *7
*1
*10
*6
*8
Note *4 *5
1.How to set the time
1) Pull out the crown to the second click position.
2) Turn the crown to set hour and minute hands.
(Check that AM / PM is set correctly.)
3) Push the crown back into the normal position.
[ Note ]
2.How to set the date
1) Pull out the crown to the first click position.
2) Turn the crown clockwise for date setting.
*Do not set the date between 9:00 P.M. and 3:00 A.M. as this will cause a malfunction.
3) Push the crown back into the normal position.
3.How to reset (after battery change)
It is possible to reset by the following two methods.
1) Set the crown to the normal position.
Method 1
2) Touch the AC terminal of circuit block and the switch spring with conductive tweezers
to reset the circuit.
3) The small second hand will move at two-second interval for 10 seconds.
1) Pull out the crown to the second click position.
Method 2 2) Press the button (B) for two seconds and release the button.
3) Push the crown back to the normal position.
4) The small second hand will move at two-second interval for 10 seconds.
* If the crown is operated within this 10 seconds, the two-second interval movement will not activate.
OPERATION
DISPLAY AND CROWN / BUTTON OPERATION
*1: Hour hand
*8: Button (B) (RESET)
*2: Minute hand
*3: Chronograph second hand *11:
*4:
*9 *11
Small second hand
*7:
13
*9: Crown at normal position
If the crown is pulled to the second position while the chronograph is started, the chronograph hands
will continue to move. This is not a malfunction.
*5: 24 hour hand
Crown at first position
(Date setting)
Crown at second position
(Time setting)
<< VK83 >>
*10:
Button (A) (START / STOP)
*6: Chronograph minute hand
(20 minute)

Version-01
Cal.VK83A
[ Note ]
It is not necessary to set the chronograph hands after the battery is exchanged.
If the chronograph hands position are incorrect, following below procedure all the chronograph hands
will be reset to "0" position.
[ Standard measurement ]
Press button (A) to start the Press button (A) again to stop the Press button (B) to reset the
chronograph.
chronograph. chronograph.
The chronograph second The chronograph hands stop to All the chronograph hands
hand will start moving. indicate the elapsed time.
will be reset to "0" position.
Note
The chronograph can measure up to 20 minutes.
The chronograph stops after a measurement for 20 minutes.
*Restart in the following procedure.
*During the chronograph operation, button (B) (reset) can be pushed. There is no problem with the function.
[ Accumulated elapsed time measurement ]
A / A B
OPERATION
14
Button (A)
(START)
Button (A)
(STOP)
Button (B)
(RESET)
HOW TO USE THE CHRONOGRAPH
Press the buttons in the following order :
Press the buttons in the following order : A A
A A B
START STOP (Finish) RESET
( 10 minutes 40 seconds )
Button (B)
(RESET)
Button (A)
(START)
( 5 minutes 20 seconds ) ( 10 minutes 40 seconds )
*Restart and stop of the chronograph can be repeated as many times as necessary by pressing button (A)
START STOP / RESTART STOP RESET