Tommee Tippee express User manual

Pouch and Bottle Warmer
INSTRUCTIONS FOR USE
express G oand
Mayborn ANZ Pty Ltd. (ABN 66 154 703 134)
PO Box 475, Mt Waverley VIC 3149 AUSTRALIA
Mayborn Group is a business name of Mayborn ANZ Pty Ltd.
Newborn Brands (NZ) Ltd. PO Box 47-677
Ponsonby Auckland 1144 NEW ZEALAND
Please read and retain this important information for future reference.
Copyright © Jackel International Limited 2015
Model Number: 1118
Voltage: 230V-240V 50/60Hz 500-540W
This product complies with European Low Voltage Directive
2014/35/EU and EMC Directive 2014/30/EU
Jackel International Limited retains all intellectual property rights to this
product and packaging, including all two and three dimensional designs,
graphic images, logos and text. Any unauthorised manufacture,
publication, reproduction, communication or adaptation of any
materials comprised in this product or its packaging is strictly
prohibited and may constitute infringement of relevant laws.
Jackel International Limited is incorporated in England and Wales under
company number 01894022.
TOMMEE TIPPEE and CLOSER TO NATURE are registered trademarks
of Jackel International Limited.
Any questions?
Visit our website www.closertonaturebaby.com
or call us FREE on AUSTRALIA: 1800 096 938
NEW ZEALAND: 0800 726 436
Mayborn ANZ Pty Ltd. (ABN 66 154 703 134)
PO Box 475, Mt Waverley VIC 3149 AUSTRALIA
Mayborn Group is a business name of Mayborn ANZ Pty Ltd.
Newborn Brands (NZ) Ltd. PO Box 47-677
Ponsonby Auckland 1144 NEW ZEALAND
Leaflet Number: 0231010
www.closertonaturebaby.com
IMPORTANT WARNINGS
KEEP THIS INSTRUCTION SHEET FOR FUTURE REFERENCE AS IT INCLUDES
IMPORTANT INFORMATION.
Please ensure that you read these instructions thoroughly and use the
appliance in accordance with instructions strictly. Please note misuse may lead
to injury. Do not immerse in water. This appliance can be used by children aged
from 14 years and above if they have been given supervision or instruction
concerning the use of the appliance in a safe way and understand the hazards
involved. Cleaning and user maintenance shall not be made by children unless
they are aged 14 years and above and supervised. Keep the appliance and its
cord out of reach of children aged less than 3 years. Appliances can be used by
persons with reduced physical, sensory or mental capabilities or lack of
experience and knowledge if they have been given supervision or instruction
concerning use of the appliance in a safe way and understand the hazards
involved. Children shall not play with this appliance. Ensure that the heating
guidelines are followed to ensure that the food is not heated for too long.
For your child’s safety – Always check food temperature before feeding by
testing on a sensitive part of your skin. This appliance is intended for household
use only. Do not use outdoors. User maintenance other than cleaning and
descaling is not required for this product. Do not operate any appliance with a
damaged cord or plug or after the appliance malfunctions or has been damaged
in any manner. If the supply cord is damaged, it must be changed by a qualified
person in order to avoid a hazard. If the damage is from new, the unit must be
returned to the manufacturer. If within a retail warranty period and proof of
purchase retained; this product should be exchanged at place of purchase.
The manufacturer will then be made aware.
Any questions? Visit our website www.closertonaturebaby.com
or call us FREE on
AUSTRALIA: 1800 096 938
NEW ZEALAND: 0800 726 436
These instructions can also be found at www.closertonaturebaby.com
Pouch and Bottle Warmer
TEMPERATURE SELECTION
FROZEN
FRIDGE
ROOM
TEMP
BOTTLE TYPE SELECTION
POUCH
GLASS
BOTTLE
PLASTIC
BOTTLE
VOLUME OF FEED SELECTION
180ml/6floz
120ml/4floz
60ml/2floz
• Replace water after every use
• Do not open lid whilst red light is on and unit is in operation
• If mains power is disconnected unit will reset
• Unit does not maintain temperature of feed
• Unit will not allow you to change the selection whilst in operation
• Do not store a bottle or pouch in the unit
LID
POUCH
BASKET
TEMPERATURE
SELECTION
POUCH OR BOTTLE
TYPE SELECTION
POWER
BUTTON
VOLUME OF FEED
SELECTION

2. USAGE For your childs safety always check food temperature before feeding by testing on a sensitive part of the skin
To turn on the unit - hold down the
power button for 2 seconds, the
LED will flash red and beep once
to show that the unit is in
standby mode
1 2
Select pouch or bottle type - press
until the green LED is adjacent to
your requirement
3
Select volume of feed - press until
the green LED is adjacent to your
requirement
4
Insert feed - we recommend using
the pouch holder to support all milk
storage pouches, Bottles can be
placed directly in to the base of the
unit. For hygiene we recommend
leaving the hood on the teat
5
Close the lid
6
Press the power button - LED will
turn solid red and beep once to
show the cycle has started
Select temperature - press until the
green LED is adjacent to your
requirement
7
When cycle finishes the unit will
beep 3 times and red light will
start to flash. Unit will
automatically turn off when
cycle is complete and reset
8
Open lid and remove feed taking
care not to touch the water inside
the unit as it will have heated during
the cycle. Empty unit and replace
water after every use to ensure it
holds the correct amount
9
To cancel a cycle - hold down the
power button and the temperature
selection button for 5 seconds and
unit will reset
1. SETUP Please refer to instructions leaflet before use and remember to clean and descale your unit regularly
Fill base unit with
250mls/9oz water
1
If heating a pouch, insert pouch
holder - bottles can be placed
directly in to the base of the unit
2
Plug unit in to mains power supply
and place the unit on a clean, dry
kitchen work surface
3
Hold down the power button for
2 seconds to turn on the unit. The
LED will flash red and beep once to
show the the unit is in standby
mode
4
The unit is now ready to use
5
RESET
There are two methods of descaling that you can follow for your warmer.
DESCALING
We recommend carrying out the descaling process
approximately every 4-weeks. If you notice limescale earlier
than 4-weeks, descaling may be required sooner. Living in
a hard water area can produce limescale quicker than other
areas. You can find out your water quality via your water
provider.
You may need to repeat either process if you find that
limescale is still present.
Alternatively, you may wish to use a specific descaling
solution suitable for electric warmers if your build up is
significant, you may need to use a stronger solution.
The descaling process will remove deposits of calcium and other
minerals in the system that may affect its performance
Option 2:
1. Empty the electric warmer and wipe down the inside with a clean sponge or
damp cloth.
2. Pour in 250ml of white vinegar.
3. Turn on the warmer and run for a cycle, approximately 5-minutes.
4. Unplug the unit and leave to cool, then pour any remaining liquid down the
sink. Rinse the interior of the warmer well, with cold water and use a clean
or damp cloth to remove any build up that came loose as a result of the
descaling/cleaning process.
5. Plug unit back in and add regular amounts of water you use for normal
warming. Turn on and run for 5 minutes to remove any additional build up.
Upon completion, rinse warmer again and use as directed.
Option 1:
1. Empty the electric warmer and wipe down the inside with a clean sponge or
damp cloth.
2. Pour in 250ml of white vinegar.
3. Leave for at least 30 minutes, or up to 24-hours depending on the extent of
the limescale.
4. Pour any remaining liquid down the sink. Rinse the interior of the warmer
well with cool water and use a clean sponge or damp cloth to remove any
build up that came loose as a result of the descaling/cleaning process.
5. Plug unit back in and add regular amounts of water you use for normal
warming. Turn on and run for 5 minutes to remove any additional build up.
Upon completion, rinse warmer again and use as directed.
CLEANING
After each use, unplug and allow to cool before cleaning.
Pour away any excess water and wipe with a damp cloth
only. Do not clean with abrasive cleaners or allow to come
in to contact with solvents or harsh chemicals, damage
could result.
3. CLEANING & DESCALING