Toro TR50 Manual

TR50
Series
Rotor
Align the cap arrow with the left side
of the watering area. This is the non-
adjustable side of the watering arc.
Watering Arc Adjustment
Turn the arc adjustment ring to align
the white arrow to the right side of
the watering arc.
The watering area is between the cap arrow and the
adjustment ring arrow. This example is set to 180°.
Turn the adjustment ring 90° to the
left to decrease the arc.
The watering area can be adjusted between 30° and 360°.
When set to 360°, the nozzle does not reverse direction.
Instruction Guide

© 2003 The Toro Company, Irrigation Division •An ISO-9000 Certified Company •www.toro.com Form Number 373-0290 Rev. A
The TR50 sprinkler comes
with eight additional nozzle
sizes from 1 to 9 GPM. To
change the nozzle, use the
blade end of the sprinkler tool
or a screwdriver to turn the
nozzle screw out until it clears
the nozzle. Pry the nozzle out
at the bottom and install the
new nozzle. Return the nozzle
screw to its previous position.
Turn the nozzle screw in to diffuse and
shorten the spray radius.
To prevent low head
drainage, install check
valve disk in position B.
Remove and
flush screen
as needed.
Changing Nozzle
Adjusting Spray Cleaning Screen
Install Check Valve
Align riser
with body as
shown when
reassembling.
P/N 102-1303
P/N 102-2802