Toshiba S15 Instruction Manual




Page: 1 of 2
©2015 Toshiba International Corporation

Fast Start Guide
When commissioning a VFS15, the first step is to ensure the correct logic is selected with SW1. Sink logic is the
left position, and source logic is the right position. Applications with dry contact controls will use sink logic,
and controls supplying 24 Vdc will use source logic.
On first power up, the unit will ask you to select a country of operation. Select usa. Once the screen shows
0.0, hit the mode button once. auh should be displayed. Turn the setting dial clockwise until you see the
following parameters, and use the enter button to change the value. Once the value is changed, use the enter
button again to save the changes.
The following is not a comprehensive list for every application, but contains all the recommended parameters from Toshiba for a simple S15 setup.
PARAMETER DESCRIPTION DEFAULT ADJUSTMENT RANGE
cmod Command Mode Selection
(Start/Stop Command) 1: Panel Keypad
0:Terminal Block
1: Panel Keypad
2:RS485 Communication
3: CANopen Communication
4: Communication Option
S15 Application Guideline 6.0
EnterButton
M
ode
B
utto
n
Settin
g
Dial




Page: 2 of 2
©2015 Toshiba International Corporation

Note: DEFAULT values are based on user selecting usa on the setup menu.
To access the remaining parameters, use the setting dial to scroll through the programming menu until you see
f4--. Hit the enter button, and then scroll to the parameter numbers to make changes.
PARAMETER DESCRIPTION DEFAULT ADJUSTMENT RANGE
f405 Motor Rated Capacity --- kW 0.01-22.0 kW
f415 Motor Rated Current --- A 0.01-100.0 A
f417 Motor Rated Speed 1710 RPM 100-64000 RPM
f701 Current/Voltage Unit Selection 0: % 0: %
1: A/V
Revision History:
Rev. Date Written/Revised
By
Approved By Description
0 7/29/2015 Joshua Austin Felipe Reyna Original Document.
For additional assistance, please contact Toshiba Adjustable Speed Drive Marketing Dept. at [phone].
Website: www.toshiba.com/tic YouTube: TICTalk - https://www.youtube.com/user/ToshibaIndustrial
PARAMETER DESCRIPTION DEFAULT ADJUSTMENT RANGE
fmod Frequency Setting Mode Selection 1
(Frequency Reference) 0: Setting dial 1
0: Setting dial 1
1: Terminal VIA (0-10Vdc)
2: Terminal VIB (0-10Vdc)
3: Setting dial 2
4: RS485 Communication
5: UP/DOWN from external logic input
6: CANopen Communication
7: Communication Option
8: Terminal VIC (4-20mA)
11: Pulse Train Input
14: sr0
acc Acceleration Time 1 10.0 s 0.0-3600 s
dec Deceleration Time 1 10.0 s 0.0-3600 s
ul Upper Limit Frequency 60.0 Hz 0.5-fh Hz
ll Lower Limit Frequency 0.0 Hz 0.0-ul Hz
vl Base Frequency 1 60.0 Hz 20.0-500.0 Hz
vlv Base Frequency Voltage 1 230 (230V class)
460 (460V class)
50-330 (230V class)
50-660 (460V class)
pt V/Hz Control Mode Selection 0: Constant Torque
0:Constant Torque
1:Variable Torque
2: Automatic Torque Boost Control
3: Vector Control
4: Energy-Saving
5: Dynamic Energy-Saving
6: PM Motor Control
7: V/F 5-Point Control
thr Motor Electronic Thermal-Protection
Level 1 100 % 10-100 %