Toto EGO II TX442SESN User manual

SPECIFICATIONS
OPERATING CONDITIONS
S06243S
TROUBLESHOOTING
CHECK
POINT
Water leaks around the handle 1 Tighten
Handle is loose 2 Tighten
PROBLEM
SOLUTION
2. BOLT
1. CONNECTING NUT
TX442SESN
MAINTENANCE
WALL
Ø162
500
-20
126
62.5
G½
G½
70
G½
G½
140
810
-20
3.
2.
Handle
Bolt
Cover *
Bolt Mortar
* Remove the cover after the mortar dry
Hex. Key
Index
R7
Ring w/ O-ring
Flange
Ring w/ O-ring
INSTALLATION
1.
Cold Water
Supply *
Hot Water
Supply *
ToShower Head *
* Pipe supplied by owner
ToBath Spout *
Water supply pressure : 0.05 ~ 0.75 MPa.
Ensure that water supply is clean ( No Sand, Dirt, Etc.).
1.
2.
Maximum
Mortar Level
Minimum
Mortar Level
Packing
ATTENTION
"EGO II" SINGLE LEVER BATH & SHOWER MIXER
W/ DIVERTER
All Finishes : Clean the finish with mild soap and warm water.
Wipe entire surface completely dry with clean soft cloth. Many
cleaners may contain chemicals, such as ammonia, chlorine,
toilet cleaner etc. which could adversely affect the finish and are
not recommended for cleaning
1.Don t use abrasive cleaners or solvents on faucets and fittings.
As the product model is constantly updated, the actual product
may not look the same as it shown in the diagram, but the
basic installation principles are the same.
2.

SPESIFIKASI
KONDISI OPERASIONAL
S06243S
PENYELESAIAN MASALAH
Air bocor disekitar handle 1 Kencangkan
Handle longgar 2 Kencangkan
MASALAH
SOLUSI
POIN
PERIKSA
2. BOLT
1. CONNECTING NUT
TX442SESN
PEMELIHARAAN
3.
2.
Handle
Bolt
Cover *
Bolt Mortar
* Lepas cover setelah mortar mengering
Hex. Key
Index
R7
Ring w/ O-ring
Flange
Ring w/ O-ring
PEMASANGAN
1.
Cold Water
Supply *
Hot Water
Supply *
ToShower Head *
* Pipa disediakan oleh pemilik
ToBath Spout * Maximum
Mortar Level
Minimum
Mortar Level
Packing
PERHATIAN
"EGO II" SINGLE LEVER BATH & SHOWER MIXER
W/ DIVERTER
1. Tekanan sumber air: 0.05 ~ 0.75 MPa.
2. Pastikan kondisi sumber air adalah bersih
(tidak ada pasir, kotoran dan lain lain)
WALL
Ø162
500
-20
126
62.5
G½
G½
70
G½
G½
140
810
-20
Seluruh lapisan : Bersihkan lapisan akhir dengan sabun lembut
dan air hangat. Lap seluruh permukaan hingga benar-benar
kering dengan kain lembut yang bersih. Kebanyakan bahan
pembersih mungkin mengandung bahan kimia, seperti amonia,
klorin, pembersih toilet, dll. yang dapat mempengaruhi hasil
akhir dan tidak disarankan untuk dibersihkan
1.Jangan gunakan pembersih atau pelarut abrasif pada faucet
dan fitting.
Karena model produk terus mengalami pembaharuan, aktual
produk mungkin tidak sama dengan gambar, tapi prinsip
dasar pemasangan adalah sama.
2.