
10
Emptying the Dust Tank:
1. To empty the dust tank, begin by pulling the release button at the top of the
unit to separate it from the main unit.
2. Once the tank has been separated from the unit, twist the tank lid counter-
clockwise to loosen it. Pull the lid away from the main body of the unit to
access the round lter.
3. Remove the round lter from the unit and tap it lightly against a dustbin or
sink to clean it.
4. Pull the inlet lter out of the dust tank and shake the tank’s contents into a
dustbin
5. Once you have emptied the dust tank, t both lters back into place and re-
attach the tank lid. Twist the tank lid clockwise to lock it and secure the dust
tank in place.
6. Once the dust tank is secured, pull the tank release tab back and afx the tank
back onto the body of the unit. The release tab will automatically click into
place and secure the dust tank to the unit.
Cleaning the Unit Body:
1. Before cleaning the unit body, ensure the unit is disconnected from the mains
supply and not in operation.
2. Use a damp cloth to clean the unit body. Never use any abrasive cleaning
materials or solvents, as these could cause damage to the surface of the unit.
WARNING! DO NOT allow any liquids into the unit, as this could cause damage to
the electrical components and cause it to malfunction.
Wall-Mounting the Unit:
1. This unit comes complete with a wall mounting kit, for easy storage.
2. To wall-mount the vacuum, begin by installing the wall-mounting kit. To do
this, rst place the kit against the wall where it is to be installed, ensuring it is
correctly positioned. The wall-mounting kit is correctly positioned when the
protruding ridge is on the underside of the base.
3. Once the kit is correctly positioned, use a pencil to mark the location of the two
screw-holes at the top and bottom of the unit.
4. Remove the kit from the wall and drill two holes, in accordance with the
markings.
5. Insert a wall plug (included) into each of the two holes.
6. Once the wall plugs are in place, slot the wall mount into the wall, ensuring
each of the two holes on the body of the unit aligns with one of the wall plugs.
7. Hold the wall mount in position and thread one of the two included screws
through each of the corresponding holes on the body of the unit and into each
of the wall plugs, ensuring they sit ush inside the plug. Use a screwdriver to
tighten each screw and secure the wall mount into place.
8. To place the vacuum cleaner onto the wall mount, hang it from the small
bracket at the centre of the mount, ensuring it is rmly secured into place.
Storing the Appliance:
1. Before storing the appliance, insert the oor brush holder and the tubes into
the storage clip at the rear of the appliance.
2. Your appliance can now be stored.
8 - Cleaning & Care