
9
5. Twist the cyclonic filter and remove from the unit. Tap it lightly against a dustbin or sink to
remove particles.
6. Press the button on the filter frame and pull the inlet filter out. Tap it lightly against a dustbin
or sink to remove particles. Alternatively, rinse the filter under running water and leave it to dry
thoroughly before placing it back into the unit.
7. Once the dust tank is empty and filter is dry, replace the filter and re-attach the tank lid. Twist
the tank lid clockwise to lock it and secure the dust tank in place.
8. Once the dust tank is secured, pull the tank release tab back and affix the tank back onto the
body of the unit. The release tab will automatically click into place and secure the dust tank to
the unit.
9. Ensure the filter is dry before inserting it back into the unit.
Cleaning the Unit Body:
1. Before cleaning the unit body, ensure the unit is disconnected from the mains supply and not
in operation.
2. Use a damp cloth to clean the unit body. Never use any abrasive cleaning materials or solvents,
as these could cause damage to the surface of the unit.
WARNING! DO NOT allow any liquids into the unit, as this could cause damage to the electrical
components and cause it to malfunction.
Note: Ensure the unit is thoroughly clean and the filter is completely dry before attempting to use or
store it.
Cleaning the Interchangeable floor head brush bar:
Press the locking button on the underside of the brush head, remove the lock pin and lift out the
brush bar.
1. Lift the lever on the edge of the underside of the floor head and pull out the brush bar.
2. Remove fluff, hairs and other dirt from the brush, then fit it back into place.
3. Push the lever back down to lock the brush bar in place.
Clearing Blockages:
If the dust tank is overfilled, the filter is clogged up, or the vacuum picks up a larger piece of debris,
the vacuum may become clogged.
Should this occur, carry out the following steps to unclog the vacuum:
1. Check the dust tank and empty it if necessary.
2. Check the filter for any debris and rinse it under running water if necessary, as detailed in the
sections above.
3. Detach any attachments from the unit and check for blockages.
Storing the Appliance:
1. Before storing the appliance, insert the accessories into the storage clip at the rear of the
appliance.
2. Store the appliance in a cool, dry place, preferably inside its original packaging, and out of the
reach of children.