TRAMEX MEP User manual

MEP
Moisture Encounter Plus
QUICK START GUIDE
www.tramexmeters.com
•
•
•
•
•
TROUBLESHOOTING
All LED’s flashing when unit is powered up.
Battery is low and will soon need to be
replaced with an Alkaline battery.
Single LED flashing and meter frozen.
MEP is in HOLD mode.
Press HOLD button to release.
www.tramexmeters.com
USER GUIDE ONLINE
Please use the following link or QR code to
access the complete User Guide online:
l.ead.me/barWQQ
LI-MEPQSG

OPERATION
SCALE USE
CALIBRATION & WARRANTY
•
•
•
•
•
•
•
Press the ON/OFF button.
•
•
•
•
•
•
Obtain Warranty online:
tramexmeters.com/register
Press Scale button to select the required
mode.
Press MEP fully against the surface of the
material.
Readings are instant and displayed on the
analog screen.
Last scale used is memorized when power is
shut down and automatically selected next
time unit is powered up.
Turn Audio signal on or off by pressing
HOLD/AUDIO twice in quick succession.
To freeze the readings press the HOLD/AUDIO
button once, LED for selected scale will flash
slowly.
If MEP is shut down in HOLD mode, it will retain
the stored reading when powered up next and
remain in HOLD mode with the LED for the
selected scale flashing.
Automatic power timeout (10 mins) conserves
battery life.
Upper scale (5-30) indicates moisture
content (MC%) of wood when used on wood
products.
Lower Scale (0-100) is a comparative scale and
may be used for recording and comparing
moisture condition in materials other than
wood.
Annual calibrations are recommended as
best practice. Calibration Check Boxes can
be purchased for regular checks:
Product code: CALBOXMEP