Transition Networks PS-T-SIC User manual
Installation
Twinax SIC Card
(PS-T-SIC)
CAUTION: Wear a grounding device and observe electrostatic
discharge precautions when installing the Twinax SIC card. Failure to
observe this caution could result in circuit board failure.
To install Twinax SIC card:
1. Remove SIC slot cover plate from hub by removing two (2) 6-32
installation screws. NOTE: Retain screws for Step 5.
2. Carefully slide Twinax SIC card into onto hub installation guides
(inside hub SIC card installation slot) until SIC card is firmly seated
against internal circuit connector.
3. Install two (2) washers (provided) over the two external Twinax
connectors.
4. Slide metal enclosure over connectors, as shown.
5. Secure Twinax SIC card to hub using the two (2) retained 6-32
installation screws, as shown.
33002.A
Washers
Enclosure
Installation Screws
Installation Slot
Table of contents
Other Transition Networks Computer Hardware manuals
Transition Networks
Transition Networks PCM16-FX-LC-01 User manual
Transition Networks
Transition Networks N-GXE-POE-EPS-KIT User manual
Transition Networks
Transition Networks REDUNDANT E-FL/RED-SIC User manual
Transition Networks
Transition Networks E-BR-SIC User manual
Transition Networks
Transition Networks NM2-FXS-2230-SFP-201 User manual
Popular Computer Hardware manuals by other brands
EMC2
EMC2 VNX Series Hardware Information Guide
Panasonic
Panasonic DV0PM20105 Operation manual
Mitsubishi Electric
Mitsubishi Electric Q81BD-J61BT11 user manual
Gigabyte
Gigabyte B660M DS3H AX DDR4 user manual
Raidon
Raidon iT2300 Quick installation guide
National Instruments
National Instruments PXI-8186 user manual
