Transition Networks TN-J4858C User manual

*Unless otherwise indicated, the distances listed are the typical maximum cable
distance. The actual maximum cable distance is dependent on the physical
characteristics of the network installation.
Notice: Transition Networks' SFP modules fully comply with the Multi-Sourcing
Agreement (MSA). This compliance allows our SFP modules to be used in
other MSA compliant SFP platforms without problems. In addition, TN SFP
modules specified in this manual are also compatible with all HP SFP-based
ProCure Switches, including the software. TN SFP modules ARE NOT HP
OEM brand modules.
User’s Guide
TN-J48xxx HP Compatible Small
Form Factor Pluggables (SFPs)
Transceiver Module
The Transition Networks TN-J48xxx SFP series
small form factor pluggable (SFP) transceiver
modules are designed to install in any SFP port.
The TN-J48-xxx SFP transceivers are designed for bi-directional, serial-optical data
communications such as Gigabit Ethernet or fiber channels at speeds up to 1.25 Gbps.
Installation . . . . . . . . . . . . . . . . . . . . . . . . .2
Cable Specifications . . . . . . . . . . . . . . . . .3
Technical Specifications . . . . . . . . . . . . . .4
Contact Us . . . . . . . . . . . . . . . . . . . . . . . . .6
Compliance Information . . . . . . . . . . . . . .7
Part Number Port Description
TN-J4858C 1000Base-SX, duplex LC, 850 nm, multimode
220 m (722 ft)* on 62.5/125 µm fiber
550 m (1804.5 ft)* on 50/125 µm fiber
TN-J4859C 1000Base-LX, duplex LC 1310 nm, single mode
up to 20 km (12.3 miles)*
TN-J4860C 1000Base-LX/ZX, duplex LC 1550 nm, single mode
up to 80 km (49.7 miles)*

TN-J48xxx SFPs
2Tech Support: 1-800-260-1312 -- International: 00-1-952-941-7600—24 hours
Connect the fiber cable
to the SPF transceiver
module as shown.
Connect the fiber cable
to the other device
(media converter, hub,
etc.) as shown.
RX
TX
RX
TX
Installing the fiber cable
1. Locate a 1000Base-SX compliant or 1000Base-LX compliant fiber cable
with male Tx to Rx connectors installed at both ends.
2. Install the fiber cable as shown below.
Installation
Installing the SFP transceiver
To install the SFP module into a network switch or media converter, do the
following:
1. Position the module at the installation slot so that the label side faces up.
2. Carefully slide the module into the installation slot, aligning it with the internal
installation guides.
Cable Specifications
Fiber cable
The physical characteristics must meet or exceed IEEE 802.3z™specifications.
Single mode fiber (recommended): 9 µm
TN-J4858C 850 nm multimode
Fiber Optic Transmitter Power: min: -9.0 dBm max: -3.0 dBm
Fiber Optic Receiver Sensitivity: min: -18.0 dBm max: -0.0 dBm
Link Budget: 9.0 dB
TN-J4859C 1310 nm multimode
Fiber Optic Transmitter Power: min: -9.0 dBm max: -3.0 dBm
Fiber Optic Receiver Sensitivity: min: -25.0 dBm max: -3.0 dBm
Link Budget: 16.0 dB
TN-J4860C 1550 nm single mode
Fiber Optic Transmitter Power: min: -0.0 dBm max: -5.0 dBm
Fiber Optic Receiver Sensitivity: min: -24.0 dBm max: -3.0 dBm
Link Budget: 24.0 dB

TN-J48xxx SFPs
4Tech Support: 1-800-260-1312 -- International: 00-1-952-941-7600 -- (24 hours)
Technical Specification
For use with Transition Networks Model TN-J48-xxx or equivalent.
Standard: IEEE 802.3 2003; ANSI X3.297-1997
TN-J48xxx SFP modules compliant with:
IEEE 802.3z Gigabit Ethernet
.
Dimensions: 0.52 x 2.22 x 0.33 in (13.4 x 56.5 x 8.5 mm, Fiber)
Weight: 1 oz. (28 g) approximately
Power: 3.3V, Fiber 0.66 W
Operating Temp: 0°C to 70°C (32°F to 158° F )
Storage Temp: -40°C to 85°C (-40° to 185°F)
Humidity: 5% to 95%, non-condensing
Warranty: Lifetime
Note: Transition Networks' SFP modules fully comply with the Multi-Sourcing
Agreement (MSA). This compliance allows our SFP modules to be used in
other MSA compliant SFP platforms without problems.
Contact Us
Technical support
Technical support is available 24 hours a day.
U.S.A. and Canada: 1-800-260-1312
International: 00-1-952-941-7600
Transition now
Chat live via the Web with Transition Networks Technical Support.
Log onto www.transition.com and click the Transition Now link.
Web-Based seminars
Transition Networks provides seminars via live web-based training.
Log onto www.transition.com and click the Learning Center link.
E-Mail
Ask a question anytime by sending an e-mail to our technical support staff.
Address
Transition Networks
10900 Red Circle Drive
Minnetonka, MN 55343, U.S.A.
telephone: 952-941-7600
toll free: 800-526-9267
fax: 952-941-2322

TN-J48xxx SFPs
6Tech Support: 1-800-260-1312 -- International: 00-1-952-941-7600 -- (24 hours)
Declaration of Conformity
Name of Mfg: Transition Networks
10900 Red Circle Drive, Minnetonka MN 55343 U.S.A.
Model: TN-J48xxx SFP Series Transceiver Modules
Part Number(s): TN-J4858C, TN-J4859C, TN-J460C
Regulation: EMC Directive 89/336/EEC
Purpose: To declare that the TN-J48xxx to which this declaration refers
is in conformity with the following standards:
IEC 60825-1; IEC60825-2; FC1X/2X SM-LC-L FC-PI; IEEE 802.3z 2003; ANSI X3.297
1997; Class A; FDA 21; CFR1040.10; CFR1040.11
I, the undersigned, hereby declare that the equipment specified above conforms to the above
Directive(s) and Standard(s).
August 2009___
Stephen Anderson, Vice-President of Engineering Date
Compliance Information
CE Mark: IEC-60825; FDA 21; CFR 1040.10 and 1040.11
FCC regulations
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference, in which
case the user will be required to correct the interference at the user's own expense.
Canadian regulations
This digital apparatus does not exceed the Class A limits for radio noise for digital apparatus set out
on the radio interference regulations of the Canadian Department of Communications.
Le présent appareil numérique n'émet pas de bruits radioélectriques dépassant les limites
applicables aux appareils numériques de la Class A prescrites dans le Règlement sur le brouillage
radioélectrique édicté par le ministère des Communications du Canada.
European regulations
Warning
This is a Class A product. In a domestic environment this product may cause radio interference in
which case the user may be required to take adequate measures.
Achtung !
Dieses ist ein Gerät der Funkstörgrenzwertklasse A. In Wohnbereichen können bei Betrieb dieses
Gerätes Rundfunkstörungen auftreten. In diesem Fäll ist der Benutzer für Gegenmaßnahmen
verantwortlich.
Attention !
Ceci est un produit de Classe A. Dans un environment domestique, ce produit risque de créer des
interférences radioélectriques, il appartiendra alors à l'utilsateur de prende les measures spécifiques
appropriées.
In accordance with European Union Directive 2002/96/EC of the European Parliament
and of the Council of 27 January 2003, Transition Networks will accept post usage
returns of this product for proper disposal. The contact information for this activity can
be found in the 'Contact Us' portion of this document.
CAUTION: RJ connectors are NOT INTENDED FOR CONNECTION TO THE
PUBLIC TELEPHONE NETWORK. Failure to observe this caution could result in
damage to the public telephone network.
Der Anschluss dieses Gerätes an ein öffentlickes Telekommunikationsnetz in den EG-
Mitgliedstaaten verstösst gegen die jeweligen einzelstaatlichen Gesetze zur Anwendung der
Richtlinie 91/263/EWG zur Angleichung der Rechtsvorschriften der Mitgliedstaaten über
Telekommunikationsendeinrichtungen einschliesslich der gegenseitigen Anerkennung ihrer
Konformität.

Trademark notice
All trademarks and registered trademarks are the property of their respective owners.
Copyright restrictions © 2009 Transition Networks. All rights reserved. No part of this work may
be reproduced or used in any form or means (graphic, electronic, mechanical) without written
permission from Transition Networks.
33446.A
Printed in the U.S.A.
TN-J48xxx SFPs
8
This manual suits for next models
2
Table of contents
Other Transition Networks Control Unit manuals
Popular Control Unit manuals by other brands

LOVATO ELECTRIC
LOVATO ELECTRIC EXP1016 instruction manual

Boreal
Boreal WIFI2-B Installation, operating and servicing instruction

Siemens
Siemens SINUMERIK 840D sl operating manual

Bard
Bard CMA-39 Supplemental instructions

WABCO
WABCO 461 317 Test instructions

Honeywell
Honeywell Notifier XP6-R Installation and maintenance instructions