1. This product is intended for use only on data circuits with operating
voltages not to exceed 5V and operating currents not to exceed 100mA
2. Mounting the CPX Chassis: Mount the device as close as possible to the
equipment to be protected using the hardware provided in the packaging
supplies.
3. Wiring the CPX Chassis
Suppressor must be grounded for proper operation!
3.1 Install the ground connection using a dual hole compression lug (hole size
1/4” x 20 studs on 5/8” CC, suitable for acceptance of 10-4awg copper wire),
with supplied fasteners. Crimp wire to lug using approved tools.
3.2 Connect the incoming data lines to the connectors labeled ‘l’ on the
appropriate protection modules (100BT, GbE or T1/E1 ), using the text on the
module faceplates as a guide.
3.3 For the equipment to be protected, connect the corresponding lines to the
protection module connector labeled ‘O’.
4. Installing Additional Protection Modules into the CPX Chassis (See table 1)
4.1 Remove the blank cover from an unpopulated bay in the protection chassis
by removing the mounting screw(s) with a #2 Phillips screwdriver.
4.2 Slide the protection module into the open bay such that the mounting hole(s)
on the module faceplates aligns with the threaded hole(s) on the chassis, and
the “i” (input) side is at the top. Ensure that the mounting tab(s) on the
protection module seats into the slot(s) on the chassis.
4.3 Re-Install the original mounting screw(s) or use the mounting screw(s)
provided in the packaging supplies for the protection module using a #2 Phillips
screwdriver.
4.4 Wire the protection module per the instruction given in Section 3.
Table: CPX Series Protection Module Part Number
800.882.9110 or 208.772.8515
Figure 1: CPX Series Mechanical Outline Drawing
DATA PROTOCOL
1000-1268
1000-1268-NF
1000-1269
1000-1269-NF
1000-1270
1000-1270-NF
1101-972
PROTECTION MODULE PART NUMBER
CPX SERIES 10/100BASE-T PROTECTION MODULE
CPX SERIES 10/100BASE-T PROTECTION MODULE NO FUSE
CPX SERIES T1/E1 PROTECTION MODULE
CPX SERIES T1/E1 PROTECTION MODULE NO FUSE
CPX SERIES 1000BASE-T PROTECTION MODULE
CPX SERIES 1000BASE-T PROTECTION MODULE NO FUSE
KIT CPX HOUSING ASSY
