Transtector TSJ X6 Series User manual

Thank you for your recent purchase of our surge protection solution.
Your satisfaction with our product and service is important to us.
If you have any questions, comments or concerns, please contact us
at 800.882.9110 or visit our website at www.transtector.com.
We look forward to continuing to serve your protection needs.
Installation Instructions
800.882.9110 | 208.772.8515 | www.transtector.com
1. IMPORTANT SAFETY INSTRUCTIONS!
2. Read and understand all instructions before installing this
product. Save these instructions for future reference.
Important Safety
Instructions
After reading these instructions
and successfully installing this
product, please save these
instructions for future reference.
TSJ X6 Series Protectors

Installation Instructions
800.882.9110 | 208.772.8515 | www.transtector.com
The TSJ-X6 series protectors are intended to be installed indoors or within
a suitably rated NEMA enclosure for the application. The TSJ-X6 series
protectors can be mounted to any at surface by use of the four 0.23”
diameter holes on the sturdy mounting feet. These mounting feet holes are
sized for use with up to #8 drywall or similar type screws. A ground wire must
be installed from the closest ground bar to the TSJ-X6 protector #¼-20 ground
stud. This ground wire should be as large a wire gauge (8 AWG minimum) as
possible and as short a wire length as possible (3 ft maximum). Data cables
are easy to install into the RJ connectors located on each side. Note that each
independent data circuit should be orientated with incoming cables from the
left and the “Protected” cables feeding out from the right. The unit is clearly
marked for this reference. For shielded Cat5 applications with the TSJ X6
10/100 BT and TSJ X6 GbE ,the unit’s shielded jacks provide a convenient
connection to ground. For shielded Cat5 cable applications with the TSJ X6A,
the user may wish to bond each incoming and outgoing shield to the internal
ground stud for each suppressor. Trim back approximately 3 inches of shield
wire and terminate with a #6 ring lug. Loosen the single screw fastener on
the cover face near the ground stud and swing the door out of the way. This
fastener is self retained in the plastic to avoid misplacement. Carefully loosen
the #6-32 mounting nut on the suppressor board and slip the shield ring lug
onto the stud. Reattach all #6-32 suppressor mount hardware and reattach
the front cover.
TSJ X6 Series Protectors
1200-338 REV H