Travis Industries 564 User manual

564 Electric Surround Panel
Installation Instructions (8” x 8” 96100297)
Page 1 of 2 17601581 - 7/27/09 © Travis Industries, Inc.
Packing List
•Left Side Panel
•Right Side Panel
•Top Panel
Compatibility Notes
The following faces are compatible with these surround panels. Some faces have a forward offset (gap
between the face and surround panels) as noted below.
Face Forward Offset Face Forward Offset
Trim, Independence Flush (0”) FPX Architectural Dbl Door Flush (0”)
Trim, Forest Grove Flush (0”) Victorian Lace Face Flush (0”)
Trim, 564E Flush (0”) Wilmington Faces 3/16”
FPX Arched Faces 5/16” Independence Face Flush (0”)
FPX Metropolitan Faces Flush (0”)
The following faces are not compatible with this panel set:
•Bungalow Face •Tree of Life Face
•
Matrix Face
Installation Preparation and Sizing
These surround panels are used with the 564 Electric fireplace when it is installed into an existing masonry or
metal (zero-clearance) fireplace. Before installing the fireplace, thoroughly clean the interior of the fireplace.
We recommend painting the fireplace interior with latex paint to prevent odors from the fireplace from
transferring into the room from the blower inside the electric fireplace.
Fireplaces typically have a firebox floor that is recessed below the hearth (see illustration below). In these
fireplaces install a sheet of plywood or other suitable material on the firebox floor to raise it to a level that is
equal to, or slightly (1/8” or less) above the hearth. This allows the fireplace to remain level while it is slid into
position.

564 Electric Surround Panel
Installation Instructions (8” x 8” 96100297)
Page 2 of 2 17601581 - 7/27/09 © Travis Industries, Inc.
Installation
1 Remove the left side bracket on the fireplace and replace it with the left side panel (see illustration
below). Repeat this process for the right side panel.
2 The top panel has joggles on the back of the panel that slide over the flanges on the fireplace
and panels (see illustration below). Attach the top panel, making sure the ends are square with
the side panels.
3 Slide the fireplace into position. The side panels have an angled snipe at each bottom corner to
allow the power cord to exit the side panels.